> > +
> > + lan937x_pread8(dev, port, REG_PORT_XMII_CTRL_1, &data8);
> > +
> > + /* clear MII selection & set it based on interface later */
> > + data8 &= ~PORT_MII_SEL_M;
> > +
> > + /* configure MAC based on p->interface */
> > + switch (p->interface) {
> > + case PHY_INTERFACE_MODE_MII:
> > + lan937x_set_gbit(dev, false, &data8);
> > + data8 |= PORT_MII_SEL;
> > + break;
> > + case PHY_INTERFACE_MODE_RMII:
> > + lan937x_set_gbit(dev, false, &data8);
> > + data8 |= PORT_RMII_SEL;
> > + break;
> > + default:
> > + lan937x_set_gbit(dev, true, &data8);
> > + data8 |= PORT_RGMII_SEL;
> > +
> > + data8 &= ~PORT_RGMII_ID_IG_ENABLE;
> > + data8 &= ~PORT_RGMII_ID_EG_ENABLE;
> > +
> > + if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
> > + p->interface == PHY_INTERFACE_MODE_RGMII_RXID)
> > + data8 |= PORT_RGMII_ID_IG_ENABLE;
> > +
> > + if (p->interface == PHY_INTERFACE_MODE_RGMII_ID ||
> > + p->interface == PHY_INTERFACE_MODE_RGMII_TXID)
> > + data8 |= PORT_RGMII_ID_EG_ENABLE;
>
> This is interesting. If you have an RGMII port connected to an external
> PHY, how do you ensure that either the lan937x driver, or the PHY driver,
> but not both, enable RGMII delays?
What generally happens is the MAC adds no delays, and the PHY acts
upon the interface mode, inserting delays as requested.
There are a very small number of exceptions to this, for boards which
have a PHY which cannot do delays, and the MAC can. If i remember
correctly, this pretty much limited to one MAC vendor. In that case,
the MAC adds delays, if the interface mode requests it, and it always
passes PHY_INTERFACE_MODE_RGMII to the PHY so it does not add delays.
So what needs to be looked at here is what is passed to the phy
connect call? passing p->interface is definitely wrong if the MAC is
acting on it.
If even if the connect is correct, i would still prefer the MAC not do
the delays, let the PHY do it, like nearly every other setup.
Andrew
