Supply top level nodes for the STiH416 based development boards. The Pinctrl configuration has already been applied, so the only missing piece of the DT puzzle is for a board's DTB to enable the nodes. Signed-off-by: Ajit Pal Singh <ajitpal.singh@xxxxxx> Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx> --- arch/arm/boot/dts/stih416.dtsi | 44 +++++++++++++++++++++++++++++++++++++++++- 1 file changed, 43 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/stih416.dtsi b/arch/arm/boot/dts/stih416.dtsi index 84758d7..c28ef85 100644 --- a/arch/arm/boot/dts/stih416.dtsi +++ b/arch/arm/boot/dts/stih416.dtsi @@ -102,7 +102,7 @@ interrupts = <0 210 0>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_sbc_serial1>; - clocks = <&clk_sysin>; + clocks = <&clk_sysin>; }; i2c@fed40000 { @@ -236,5 +236,47 @@ resets = <&powerdown STIH416_KEYSCAN_POWERDOWN>, <&softreset STIH416_KEYSCAN_SOFTRESET>; }; + + /* SAS PWM Module */ + pwm0: pwm@fed10000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0xfed10000 0x68>; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm0_chan0_default + &pinctrl_pwm0_chan1_default + &pinctrl_pwm0_chan2_default + &pinctrl_pwm0_chan3_default>; + + clock-names = "pwm"; + clocks = <&clk_sysin>; + st,pwm-num-chan = <4>; + }; + + /* SBC PWM Module */ + pwm1: pwm@fe510000 { + compatible = "st,sti-pwm"; + status = "disabled"; + #pwm-cells = <2>; + reg = <0xfe510000 0x68>; + + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_pwm1_chan0_default + /* + * Shared with SBC_OBS_NOTRST. Don't + * enable unless you really know what + * you're doing. + * + * &pinctrl_pwm1_chan1_default + */ + &pinctrl_pwm1_chan2_default + &pinctrl_pwm1_chan3_default>; + + clock-names = "pwm"; + clocks = <&clk_sysin>; + st,pwm-num-chan = <3>; + }; }; }; -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html