The pinmuxing for the enable pin of the usbh1 node is wrong. It needs to be muxed as GPIO. While at it, move the pinctrl to the vbus regulator since it is actually the regulator enable pin. Signed-off-by: Stefan Riedmueller <s.riedmueller@xxxxxxxxx> --- arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi index 7a1e53195785..995e99952aca 100644 --- a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi +++ b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi @@ -31,6 +31,8 @@ reg_usb_otg_vbus: regulator@0 { reg_usb_h1_vbus: regulator@1 { compatible = "regulator-fixed"; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usbh1_vbus>; reg = <1>; regulator-name = "usb_h1_vbus"; regulator-min-microvolt = <5000000>; @@ -328,9 +330,9 @@ MX6QDL_PAD_KEY_ROW0__UART4_RX_DATA 0x1b0b1 >; }; - pinctrl_usbh1: usbh1grp { + pinctrl_usbh1_vbus: usbh1vbusgrp { fsl,pins = < - MX6QDL_PAD_GPIO_0__USB_H1_PWR 0x80000000 + MX6QDL_PAD_GPIO_0__GPIO1_IO00 0x80000000 >; }; @@ -415,8 +417,6 @@ &uart4 { &usbh1 { vbus-supply = <®_usb_h1_vbus>; - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_usbh1>; status = "disabled"; }; -- 2.25.1