The following series of patches - Add support for GPIO subsystem in main and wakeup domains. - Add voltage regulator device tree nodes and their corresponding pinmux to support power cycle and voltage switch required for UHS-I modes - sets respective tags in sdhci0 node to support higher speeds - remove no-1-8-v tag from sdhci1 node to support UHS-I modes - Update delay values for various speed modes supported. test logs - eMMC HS400 speed mode https://pastebin.ubuntu.com/p/pRzV2ZvSJZ/ - SD SDR104 speed mode https://pastebin.ubuntu.com/p/n64PNdDy2v/ - GPIO logs https://pastebin.ubuntu.com/p/HDBBMwMcdj/ Changes since v8: - Fixed minor changes sugested by kishon in patch 3 - Picked up kishon's reviewed-by for patch 3 Changes since v7: - Added the voltage regulator nodes to indicate the complete power flow for MMCSD1 subsystem - Corrected minor errors in DT nodes - Reran the tests. - Rebased the series Changes since v6: - Corrected the node name from vdd_sd_dv_pins_default to vdd-sd-dv-pins-default Changes since v5: - Corrected the link in patch 3 as it broken. - Added the version number for the references used in patch 3. - picked up reviewed-by from grygorii for patches 1 and 2. Changes since v4: - Added main_i2c0 pinmux required for doing power cycles to MMCSD1 subsystem - Updated delay values for various speed modes supported - Corrected the ti,ngpio property to indicate highest gpio lines that can be accessed. - Reran the performace tests Changes since v3: - Removed patch (1 in v3). - Rebased and included patches that add support for GPIO from series [1]. - Re-ran the performace tests for SD and eMMC. Changes since v2: - Added main_gpio0 DT node - Added voltage regulator device tree nodes required to support UHS-I modes Changes since v1: - squashed the two patches into one - added performance logs for the above mentioned speed modes Aswath Govindraju (1): arm64: dts: ti: k3-j7200: Add support for higher speed modes and update delay select values for MMCSD subsystems Faiz Abbas (2): arm64: dts: ti: k3-j7200: Add gpio nodes arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio modules .../dts/ti/k3-j7200-common-proc-board.dts | 94 +++++++++++++++++++ arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 86 ++++++++++++++++- .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi | 34 +++++++ 3 files changed, 212 insertions(+), 2 deletions(-) -- 2.17.1
