Re: [RFC PATCH 1/3] dt-bindings: display: simple: Add the panel on sc7180-trogdor-pompom

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Mar 16, 2021 at 02:08:19PM -0700, Douglas Anderson wrote:
> The sc7180-trogdor-pompom board might be attached to any number of a
> pile of eDP panels. At the moment I'm told that the list might include:
> - KD KD116N21-30NV-A010
> - KD KD116N09-30NH-A016
> - Starry 2081116HHD028001-51D
> - Sharp LQ116M1JW10
> 
> It should be noted that while the EDID programmed in the first 3
> panels indicates that they should run with exactly the same timing (to
> keep things simple), the 4th panel not only needs different timing but
> has a different resolution.
> 
> As is true in general with eDP panels, we can figure out which panel
> we have and all the info needed to drive its pixel clock by reading
> the EDID. However, we can do this only after we've powered the panel
> on. Powering on the panels requires following the timing diagram in
> each panel's datasheet which specifies delays between certain
> actions. This means that, while we can be quite dynamic about handling
> things we can't just totally skip out on describing the panel like we
> could do if it was connected to an external-facing DP port.

Is this a 'standard' eDP connector? AFAICT, there does seem to be 
such a thing. I've said in the past I'd be okay with a edp-connector 
node. If that needs just the "HPD absent delay" property, I think that 
would be okay. It's just a never ending stream of new properties with 
each new panel that I don't want to see.

Rob



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux