On 3/24/2021 9:58 PM, Stephen Boyd wrote:
Quoting Stephen Boyd (2021-03-24 08:57:33)
Quoting sbhanu@xxxxxxxxxxxxxx (2021-03-24 08:23:55)
On 2021-03-23 12:31, Stephen Boyd wrote:
Quoting Shaik Sajida Bhanu (2021-03-20 11:17:00)
+
+ bus-width = <8>;
+ non-removable;
+ supports-cqe;
+ no-sd;
+ no-sdio;
+
+ max-frequency = <192000000>;
Is this necessary?
yes, to avoid lower speed modes running with high clock rates.
Is it part of the DT binding? I don't see any mention of it.
Nevermind, found it in mmc-controller.yaml. But I think this is to work
around some problem with the clk driver picking lower speeds than
requested? That has been fixed on the clk driver side (see commit like
148ddaa89d4a "clk: qcom: gcc-sc7180: Use floor ops for the correct sdcc1
clk") so ideally this property can be omitted.
This is a good have dt node.
This will align clock requests between mmc core layer and sdhci-msm
platform driver. Say, for HS200/HS400 modes of eMMC, mmc-core layer
tries to set clock at 200Mhz, whereas sdhci-msm expects 192Mhz for
these modes. So we have to rely on clock driver floor/ceil values.
By having this property, mmc-core layer itself request for 192Mhz.
Same is for SD card SDR104 mode, core layer expects clock at 208Mhz
whereas sdhci-msm can max operate only at 202Mhz. By having this
property, core layer requests only for 202Mhz for SDR104 mode.
BTW, this helps only for max possible speed modes.
In case of lower-speed modes (for DDR52) we still need to rely on clock
floor rounding.
