On Wed, 24 Mar 2021 14:19:28 -0700 Florian Fainelli <f.fainelli@xxxxxxxxx> wrote: > > Another problem is that if lower modes are supported, we should > > maybe use them in order to save power. > > That is an interesting proposal but if you want it to be truly valuable, > does not that mean that an user ought to be able to switch between any > of the supported PHY <=> MAC interfaces at runtime, and then within > those interfaces to the speeds that yield the best power savings? If the code determines that there are multiple working configurations, it theoretically could allow the user to switch between them. My idea was that this should be done by kernel, though. But power saving is not the main problem I am trying to solve. What I am trying to solve is that if a board does not support all modes supported by the MAC and PHY, because they are not wired or something, we need to know about that so that we can select the correct mode for PHYs that change this mode at runtime. > > > > But for this we need to know which phy-modes are supported on the > > board. > > > > This series adds documentation for a new ethernet PHY property, > > called `supported-mac-connection-types`. > > That naming does not quite make sense to me, if we want to describe the > MAC supported connection types, then those would naturally be within the > Ethernet MAC Device Tree node, no? If we are describing what the PHY is > capable, then we should be dropping "mac" from the property name not to > create confusion. I put "mac" there to indicate that this is the SerDes to the MAC (i.e. host side in Marvell PHY). 88X3310 has another SerDes side (Fiber Side). I guess I put "mac" there so that if in the future we wanted to specify supported modes for the fiber side, we could add `supported-fiber-connection-types`. But otherwise it does not matter where this property is. Rob Herring says that maybe we don't need a new property at all. We can reuse phy-mode property of the MAC, and enumerate all supported modes there. > > > > > When this property is present for a PHY node, only the phy-modes > > listed in this property should be considered to be functional on > > the board. > > Can you post the code that is going to utilize these properties so we > have a clearer picture of how and what you need to solve? I am still working on this, so the repo may change, but look at https://git.kernel.org/pub/scm/linux/kernel/git/kabel/linux.git/log/?h=phy-supported-interfaces at the last three patches.
