From: Konstantin Porotchkin <kostap@xxxxxxxxxxx> This patch series contains the following changes/fixes: 1. Add support for Armada CN913x Development Board topology "B" 2. Add support for Armada CN913x Reference Design boards (CRB) 3. Fixes the CP11X references in PHY binding document 4. Fixes the NAND paritioninig scheme in DTS eliminating gap between consecutive partitions All above changes are already intergated into Marvell official SDK sources v2: - extract common nodes from DB boards to separate DTSI files - disable eth2 on CRB boards until the required phy mode support is added - mention the switch part ID in CRB board description v3: - do not rename setup A DTS files for DB variants - fix a couple of wrong include names v4: - Rebase on top of Linus master branch (v5.11-rc7) - Remove HS400 timing from CRB AP SDHCI (not supported by connected eMMC) - Add cd-gpio entry to CP0 SDHCI for SD card support - Add a comment to CN9130-CRB patch about the required defconfig changes for supporting the onboard i2c expander - Add Stefan's patch to enable 10G port on CN9130-DB platforms Grzegorz Jaszczyk (1): Documentation/bindings: phy: update references to cp11x Konstantin Porotchkin (3): arch/arm64/boot/dts/marvell: fix NAND partitioning scheme arm64: dts: cn913x: add device trees for topology B boards arm64: dts: add support for Marvell cn9130-crb platform Stefan Chulski (1): dts: marvell: Enable 10G interface on 9130-DB board .../bindings/phy/phy-mvebu-comphy.txt | 12 +- arch/arm64/boot/dts/marvell/Makefile | 5 + arch/arm64/boot/dts/marvell/cn9130-crb-A.dts | 38 ++ arch/arm64/boot/dts/marvell/cn9130-crb-B.dts | 46 ++ arch/arm64/boot/dts/marvell/cn9130-crb.dtsi | 221 ++++++++++ arch/arm64/boot/dts/marvell/cn9130-db-B.dts | 22 + arch/arm64/boot/dts/marvell/cn9130-db.dts | 393 +---------------- arch/arm64/boot/dts/marvell/cn9130-db.dtsi | 402 ++++++++++++++++++ arch/arm64/boot/dts/marvell/cn9131-db-B.dts | 22 + arch/arm64/boot/dts/marvell/cn9131-db.dts | 192 +-------- arch/arm64/boot/dts/marvell/cn9131-db.dtsi | 201 +++++++++ arch/arm64/boot/dts/marvell/cn9132-db-B.dts | 22 + arch/arm64/boot/dts/marvell/cn9132-db.dts | 211 +-------- arch/arm64/boot/dts/marvell/cn9132-db.dtsi | 220 ++++++++++ 14 files changed, 1223 insertions(+), 784 deletions(-) create mode 100644 arch/arm64/boot/dts/marvell/cn9130-crb-A.dts create mode 100644 arch/arm64/boot/dts/marvell/cn9130-crb-B.dts create mode 100644 arch/arm64/boot/dts/marvell/cn9130-crb.dtsi create mode 100644 arch/arm64/boot/dts/marvell/cn9130-db-B.dts create mode 100644 arch/arm64/boot/dts/marvell/cn9130-db.dtsi create mode 100644 arch/arm64/boot/dts/marvell/cn9131-db-B.dts create mode 100644 arch/arm64/boot/dts/marvell/cn9131-db.dtsi create mode 100644 arch/arm64/boot/dts/marvell/cn9132-db-B.dts create mode 100644 arch/arm64/boot/dts/marvell/cn9132-db.dtsi -- 2.17.1
