The cpu_thermal node in the rk3399-rock960.dts file does not
reference &cpu_thermal directly to add the board-specific parts,
but also repeats all the SoC default properties.
Clean the whole thing up and fix alignment.
Place new nodes in the correct alphabetical order.
Compered to rk3399.dtsi the temperature property in
cpu_alert0 changes from <70000> to <65000>.
A sustainable-power property was added.
The trip property in cooling map0 points to <&cpu_alert1>
instead of <&cpu_alert0>.
Suggested-by: Robin Murphy <robin.murphy@xxxxxxx>
Signed-off-by: Johan Jonker <jbx6244@xxxxxxxxx>
---
arch/arm64/boot/dts/rockchip/rk3399-rock960.dts | 53 +++++++------------------
1 file changed, 14 insertions(+), 39 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rock960.dts b/arch/arm64/boot/dts/rockchip/rk3399-rock960.dts
index b20774081..1a23e8f3c 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-rock960.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-rock960.dts
@@ -63,6 +63,20 @@
};
+&cpu_alert0 {
+ temperature = <65000>;
+};
+
+&cpu_thermal {
+ sustainable-power = <1550>;
+
+ cooling-maps {
+ map0 {
+ trip = <&cpu_alert1>;
+ };
+ };
+};
+
&pcie0 {
ep-gpios = <&gpio2 RK_PA2 GPIO_ACTIVE_HIGH>;
};
@@ -125,45 +139,6 @@
status = "okay";
};
-&thermal_zones {
- cpu_thermal: cpu-thermal {
- polling-delay-passive = <100>;
- polling-delay = <1000>;
- thermal-sensors = <&tsadc 0>;
- sustainable-power = <1550>;
-
- trips {
- cpu_alert0: cpu_alert0 {
- temperature = <65000>;
- hysteresis = <2000>;
- type = "passive";
- };
-
- cpu_alert1: cpu_alert1 {
- temperature = <75000>;
- hysteresis = <2000>;
- type = "passive";
- };
-
- cpu_crit: cpu_crit {
- temperature = <95000>;
- hysteresis = <2000>;
- type = "critical";
- };
- };
-
- cooling-maps {
- map0 {
-
- trip = <&cpu_alert1>;
- cooling-device =
- <&cpu_b0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
- <&cpu_b1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
- };
- };
- };
-};
-
&usbdrd_dwc3_0 {
dr_mode = "otg";
};
--
2.11.0
