Hi, This patch series adds Ultra High Speed(UHS-1) Bus Speed Mode Support for Keem Bay SoC SD Card. Summary of each patches as per below: Patch 1: Use of_device_get_match_data() helper to get the match-data. Patch 2: Convert to use np pointer instead of using pdev->dev.of_node. Patch 3: Add struct device *dev in probe func(), so that dev pointer can be widely use in probe to make code more readable. Patch 4: Change from dev_err to dev_err_probe() to avoid spamming logs when probe is deferred. Patch 5: Export function to be use by device driver to configure i/o voltage rail output which communicate with Trusted Firmware. Patch 6: Update phy and regulator supply for Keem Bay SoC. Patch 7: Add DT Binding for Keem Bay SoC SD Regulator. Patch 8: Add SD Regulator driver to support Keem Bay SoC. This is to model using standard regulator abstraction during voltage operation as for Keem Bay SoC, i/o voltage rail need to be configure by setting specific bit in the AON_CFG1 Register. AON_CFG1 Register is a secure register. Direct access to AON_CFG1 register will cause firewall violation in secure system. Patch 9: Add Ultra High Speed (UHS-1) Support for Keem Bay SOC. For Keem Bay hardware, two regulators are been used to change the I/O bus line voltage which are "vqmmc-supply" and "sdvrail-supply". All of these patches was tested with Keem Bay evaluation module board. Kindly help to review this patch set. Muhammad Husaini Zulkifli (9): mmc: sdhci-of-arasan: use of_device_get_match_data() mmc: sdhci-of-arasan: Convert to use np instead of pdev->dev.of_node mmc: sdhci-of-arasan: Add structure device pointer in probe function mmc: sdhci-of-arasan: Use dev_err_probe() to avoid spamming logs firmware: keembay: Add support for Trusted Firmware Service call dt-bindings: mmc: Update phy and regulator supply for Keem Bay SOC dt-bindings: regulator: keembay: Add DT binding documentation regulator: keembay: Add regulator for Keem Bay SoC mmc: sdhci-of-arasan: Add UHS-1 support for Keem Bay SOC .../devicetree/bindings/mmc/arasan,sdhci.yaml | 7 +- .../bindings/regulator/keembay-regulator.yaml | 36 ++ drivers/mmc/host/sdhci-of-arasan.c | 313 ++++++++++++++++-- drivers/regulator/Kconfig | 10 + drivers/regulator/Makefile | 1 + drivers/regulator/keembay-sd-regulator.c | 112 +++++++ include/linux/firmware/intel/keembay.h | 82 +++++ 7 files changed, 532 insertions(+), 29 deletions(-) create mode 100644 Documentation/devicetree/bindings/regulator/keembay-regulator.yaml create mode 100644 drivers/regulator/keembay-sd-regulator.c create mode 100644 include/linux/firmware/intel/keembay.h -- 2.17.1
