The LPC controller has no concept of the BMC and the Host partitions. The incorrect partitioning can impose unnecessary range restrictions on register access through the syscon regmap interface. For instance, HICRB contains the I/O port address configuration of KCS channel 1/2. However, the KCS#1/#2 drivers cannot access HICRB as it is located at the other LPC partition. In addition, to be backward compatible, the newly added HW control bits could be located at any reserved bits over the LPC addressing space. Thereby, this patch series aims to remove the LPC partitioning for better driver development and maintenance. This requires the change to both the device tree and the driver implementation. To ensure both sides are synchronously updated, a v2 binding check is added. Changes since v2: - Add v2 binding check to ensure the synchronization between the device tree change and the driver register offset fix. Changes since v1: - Add the fix to the aspeed-lpc binding documentation. Chia-Wei, Wang (5): dt-bindings: aspeed-lpc: Remove LPC partitioning ARM: dts: Remove LPC BMC and Host partitions ipmi: kcs: aspeed: Adapt to new LPC DTS layout pinctrl: aspeed-g5: Adapt to new LPC device tree layout soc: aspeed: Adapt to new LPC device tree layout .../devicetree/bindings/mfd/aspeed-lpc.txt | 99 +++---------- arch/arm/boot/dts/aspeed-g4.dtsi | 74 ++++------ arch/arm/boot/dts/aspeed-g5.dtsi | 135 ++++++++---------- arch/arm/boot/dts/aspeed-g6.dtsi | 135 ++++++++---------- drivers/char/ipmi/kcs_bmc_aspeed.c | 35 +++-- drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c | 19 ++- drivers/soc/aspeed/aspeed-lpc-ctrl.c | 20 ++- drivers/soc/aspeed/aspeed-lpc-snoop.c | 23 +-- 8 files changed, 232 insertions(+), 308 deletions(-) -- 2.17.1
