From: Michael Srba <Michael.Srba@xxxxxxxxx>
This patch adds 1% tolerance on input clock, similar to other camera sensor
drivers. It also allows for specifying the actual clock in the device tree,
instead of relying on it being already set to the right frequency (which is
often not the case).
Signed-off-by: Michael Srba <Michael.Srba@xxxxxxxxx>
---
drivers/media/i2c/imx219.c | 17 +++++++++++++++--
1 file changed, 15 insertions(+), 2 deletions(-)
diff --git a/drivers/media/i2c/imx219.c b/drivers/media/i2c/imx219.c
index f64c0ef7a897..a8f05562d0af 100644
--- a/drivers/media/i2c/imx219.c
+++ b/drivers/media/i2c/imx219.c
@@ -1443,13 +1443,26 @@ static int imx219_probe(struct i2c_client *client)
return PTR_ERR(imx219->xclk);
}
- imx219->xclk_freq = clk_get_rate(imx219->xclk);
- if (imx219->xclk_freq != IMX219_XCLK_FREQ) {
+ ret = fwnode_property_read_u32(dev_fwnode(dev), "clock-frequency", &imx219->xclk_freq);
+ if (ret) {
+ dev_err(dev, "could not get xclk frequency\n");
+ return ret;
+ }
+
+ /* this driver currently expects 24MHz; allow 1% tolerance */
+ if (imx219->xclk_freq < 23760000 || imx219->xclk_freq > 24240000) {
dev_err(dev, "xclk frequency not supported: %d Hz\n",
imx219->xclk_freq);
return -EINVAL;
}
+ ret = clk_set_rate(imx219->xclk, imx219->xclk_freq);
+ if (ret) {
+ dev_err(dev, "could not set xclk frequency\n");
+ return ret;
+ }
+
+
ret = imx219_get_regulators(imx219);
if (ret) {
dev_err(dev, "failed to get regulators\n");
--
2.29.2
