On Mon, Jun 23, 2014 at 12:18:39PM +0200, Lothar Waßmann wrote:
...
> > > + phy-handle = <&phy0>;
> > > + mac-address = [000000000000]; /* will be set by U-Boot */
> >
> > Shouldn't it be local-mac-address?
> >
> probably yes, but both 'mac-address' and 'local-mac-address' are being
> set up by U-Boot anyway.
Okay, never mind. I just realized kernel supports both properties.
...
> > > +&esdhc1 {
> > > + cd-gpios = <&gpio3 8 GPIO_ACTIVE_LOW>;
> > > + fsl,wp-controller;
> >
> > Does it work for you, since the driver does not support it as of today?
> >
> What driver doesn't support what?
> AFAICT the sdhci-esdhc-imx.c driver supports both of these properties.
That was the case before, but it's not the case since commit
89d7e5c13122 (mmc: sdhci-esdhc-imx: add runtime pm support).
http://thread.gmane.org/gmane.linux.kernel.mmc/27287
...
> > > + spidev0: spi@0 {
> > > + compatible = "spidev";
> > > + reg = <0>;
> > > + spi-max-frequency = <54000000>;
> > > + };
> > > +
> > > + spidev1: spi@1 {
> > > + compatible = "spidev";
> > > + reg = <1>;
> > > + spi-max-frequency = <54000000>;
> > > + };
> >
> > I'm not sure we should have these two devices.
> >
> Why not? With this the SPI bus can readily be used with the spidev
> driver from Documentation/spi/spidev_test.c (which is what most of our
> customers are asking for)!
Is this something that has been approved by DT maintainers? I do not
see "spidev" documented as a compatible in any bindings doc.
Shawn
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
