Newer SoCs starting with the Amlogic Meson G12A have more a precise
RGMII RX delay configuration register. This means more complexity in the
code. Extract the existing RGMII delay configuration code into a
separate function to make it easier to read/understand even when adding
more logic in the future.
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx>
---
drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c | 13 ++++++++++++-
1 file changed, 12 insertions(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
index 03fce678b9f5..353fe0f53620 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
@@ -268,7 +268,7 @@ static int meson8b_devm_clk_prepare_enable(struct meson8b_dwmac *dwmac,
return 0;
}
-static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
+static int meson8b_init_rgmii_delays(struct meson8b_dwmac *dwmac)
{
u32 tx_dly_config, rx_dly_config, delay_config;
int ret;
@@ -323,6 +323,13 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
PRG_ETH0_ADJ_DELAY | PRG_ETH0_ADJ_SKEW,
delay_config);
+ return 0;
+}
+
+static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
+{
+ int ret;
+
if (phy_interface_mode_is_rgmii(dwmac->phy_mode)) {
/* only relevant for RMII mode -> disable in RGMII mode */
meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
@@ -431,6 +438,10 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
goto err_remove_config_dt;
}
+ ret = meson8b_init_rgmii_delays(dwmac);
+ if (ret)
+ goto err_remove_config_dt;
+
ret = meson8b_init_rgmii_tx_clk(dwmac);
if (ret)
goto err_remove_config_dt;
--
2.29.2
