On Fri, Oct 30, 2020 at 12:29:48PM -0500, Dan Murphy wrote:
> Per the 802.3cg spec the 10base T1L can operate at 2 different
> differential voltages 1v p2p and 2.4v p2p. The abiility of the PHY to
> drive that output is dependent on the PHY's on board power supply.
Hi Dan
So this property is about the board being able to support the needed
voltages? The PHY is not forced into 2.4v p2p, it just says the PHY
can operate at 2.4v and the board will not melt, blow a fuse, etc?
I actually think it is normal to specify the reverse. List the maximum
that device can do because of board restrictions. e.g.
- maximum-power-milliwatt : Maximum module power consumption
Specifies the maximum power consumption allowable by a module in the
slot, in milli-Watts. Presently, modules can be up to 1W, 1.5W or 2W.
- max-link-speed:
If present this property specifies PCI gen for link capability. Host
drivers could add this as a strategy to avoid unnecessary operation for
unsupported link speed, for instance, trying to do training for
unsupported link speed, etc. Must be '4' for gen4, '3' for gen3, '2'
for gen2, and '1' for gen1. Any other values are invalid.
- max-microvolt : The maximum voltage value supplied to the haptic motor.
[The unit of the voltage is a micro]
So i think this property should be
max-tx-rx-p2p = <1000>;
to limit it to 1000mv p2p because of board PSU limitations, and it is
free to do 22000mv is the property is not present.
Andrew
