Re: [PATCH v2 4/7] ARM: at91/dt: split sama5d3 lcd pin definitions to match RGB mode configs

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 19/06/2014 09:07, Bo Shen wrote:
> Hi Boris,
>
> On 06/10/2014 12:04 AM, Boris BREZILLON wrote:
>> The HLCDC (High LCD Controller) IP supports 4 different output mode
>> (RGB444, RGB565, RGB666 and RGB888) and the pin muxing depends on the
>> chosen RGB mode.
>>
>> Split the pin definition to be able to set the pin config according
>> to the
>> selected mode.
>>
>> Signed-off-by: Boris BREZILLON <boris.brezillon@xxxxxxxxxxxxxxxxxx>
>> ---
>>   arch/arm/boot/dts/sama5d3_lcd.dtsi | 127
>> ++++++++++++++++++++++++++++---------
>>   1 file changed, 96 insertions(+), 31 deletions(-)
>
> On sama5d3xek board, it only works in 24bits output mode. And it
> depends on the hardware design. So, I think only keep only one pinctrl
> configuration.

As you pointed out (during our discussion on IRC) sama5d3 SoCs support
several pin muxing for LCDDAT pins.
I'll take care to define all these pin mux here and select the
appropriate ones in sama5d3xdm.dtsi (patch 6) instead of
sama5d3_lcd.dtsi (patch 5).


Best Regards,

Boris

-- 
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux