[PATCH] arm64: dts: allwinner: beelink-gs1: Enable both RGMII RX/TX delay

[Clément Péron <peron.clem@xxxxxxxxx>]

Before the commit:
net: phy: realtek: fix rtl8211e rx/tx delay config

The software overwrite for RX/TX delays of the RTL8211e were not
working properly and the Beelink GS1 had both RX/TX delay of RGMII
interface set using pull-up on the TXDLY and RXDLY pins.

Now that these delays are working properly they overwrite the HW
config and set this to 'rgmii' meaning no delay on both RX/TX.
This makes the ethernet of this board not working anymore.

Set the phy-mode to 'rgmii-id' meaning RGMII with RX/TX delays
in the device-tree to keep the correct configuration.

Fixes: 089bee8dd119 ("arm64: dts: allwinner: h6: Introduce Beelink GS1 board")
Signed-off-by: Clément Péron <peron.clem@xxxxxxxxx>
---
 arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts b/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts
index a364cb4e5b3f..6ab53860e447 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-beelink-gs1.dts
@@ -99,7 +99,7 @@ &ehci0 {
 &emac {
 	pinctrl-names = "default";
 	pinctrl-0 = <&ext_rgmii_pins>;
-	phy-mode = "rgmii";
+	phy-mode = "rgmii-id";
 	phy-handle = <&ext_rgmii_phy>;
 	phy-supply = <&reg_aldo2>;
 	status = "okay";
-- 
2.25.1