Linus Walleij writes:
> On Fri, Oct 9, 2020 at 12:00 PM Lars Povlsen <lars.povlsen@xxxxxxxxxxxxx> wrote:
>
>> > So here reg = 0 and the out port has reg 1. Isn't that what you also put
>> > in the second cell of the GPIO phandle? Then why? The driver
>> > can very well just parse its own reg property and fill that in.
>>
>> NO! The second cell is the second dimension - NOT the direction. As I
>> wrote previously, the direction is now inherent from the handle, ie. the
>> "reg" value of the handle.
>
> OK I get it ... I think :)
Great!
>
>> The hardware describe a "port" and a "bit index" addressing, where the
>> second cell in
>>
>> gpios = <&sgpio_in2 11 0 GPIO_OUT_LOW>;
>>
>> is the "bit index" - not the "reg" from the phandle.
>
> As long as the bindings specify exactly what is meant by bit index
> and the tupe (port, bit_index) is what uniquely addresses a certain
> GPIO line then it is fine I suppose.
>
Yes, that is confirmed.
>> In the example above, note
>>
>> ngpios = <96>;
>>
>> As the "port" is [0; 31], this defines "bit index" to be [0; 2], so the
>> (input) GPIO cells will be:
>>
>> p0b0, p0b1, p0b2
>> ...
>> p31b0, p31b1, p31b2
>>
>> being identical to
>>
>> <&sgpio_inX 0 0 GPIO_OUT_LOW>
>> <&sgpio_inX 0 1 GPIO_OUT_LOW>
>> <&sgpio_inX 0 2 GPIO_OUT_LOW>
>> ...
>> <&sgpio_inX 31 0 GPIO_OUT_LOW>
>> <&sgpio_inX 31 1 GPIO_OUT_LOW>
>> <&sgpio_inX 31 2 GPIO_OUT_LOW>
>>
>> ('X' being the SGPIO controller instance).
>
> So 32 possible ports with 3 possible bit indexes on each?
> This constraint should go into the bindings as well so it becomes
> impossible to put in illegal port numbers or bit indices.
>
> (Use the YAML min/max constraints, I suppose?)
>
Yes, I will to see if constraints in the GPIO args is possible.
>> So no, there *really* is a need for a 3-cell GPIO specifier (or whatever
>> its called).
>
> If that is the natural way to address the hardware lines
> and what is used in the documentation then it's fine, it's just so
> unorthodox that I have to push back on it a bit you know.
>
Yes, this piece of hw is certainly not a stock GPIO controller, so that
was kinda expected. But I think we ended up with an abstraction that
fits as good as possible.
I will send a new (last?) revision that includes the suggestions from
Rob tomorrow.
Thank you for your time and comments (also Rob!)
---Lars
--
Lars Povlsen,
Microchip
