On Tue, Sep 29, 2020 at 11:18:46AM +0200, Krzysztof Kozlowski wrote: > On Tue, 29 Sep 2020 at 11:15, Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx> wrote: > > > > Hi Krzysztof, > > > > On Wed, Sep 23, 2020 at 05:21:26PM +0200, Krzysztof Kozlowski wrote: > > > Add bindings for the IMX258 camera sensor. The bindings, just like the > > > driver, are quite limited, e.g. do not support regulator supplies. > > > > > > Signed-off-by: Krzysztof Kozlowski <krzk@xxxxxxxxxx> > > > > > > --- > > > > > > Changes since v3: > > > 1. Document also two lane setup. > > > > > > Changes since v2: > > > 1. Remove clock-frequency, add reset GPIOs, add supplies. > > > > Oops. I missed this one. > > > > How does the driver know the appropriate clock frequency for the platform > > if it's not in DT? The sensor supports a range of frequencies, not a single > > frequency. > > > > Could you add clock-frequency back? > > Not really, it was removed on Rob's request. The bindings do not > describe driver's behavior so how the driver gets frequency should not > be part of the bindings. Also it's not a real problem - the driver > just calls clk_get_rate(). Btw. we also have this nowadays: Documentation/driver-api/media/camera-sensor.rst . -- Sakari Ailus
