Configure no-pull for CTS, as this is driven by BT do not specify any pull
in order to not conflict with BT pulls.
Remove output-high from CTS and TX as this is not really required. During
bringup to fix transfer failures this was added to match with console uart
settings. Probably some boot loader config was missing then. As it is
working fine now, remove it.
Signed-off-by: satya priya <skakit@xxxxxxxxxxxxxx>
Reviewed-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
---
Changes in V4:
- This is newly added in V4 to separate the improvements in pin settings
and wakeup related changes.
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 14 ++++++--------
1 file changed, 6 insertions(+), 8 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index d8b5507..cecac3e 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -474,32 +474,30 @@
&qup_uart3_default {
pinconf-cts {
/*
- * Configure a pull-down on 38 (CTS) to match the pull of
- * the Bluetooth module.
+ * Configure no-pull on CTS. As this is driven by BT, do not
+ * specify any pull in order to not conflict with BT pulls.
*/
pins = "gpio38";
- bias-pull-down;
- output-high;
+ bias-disable;
};
pinconf-rts {
- /* We'll drive 39 (RTS), so no pull */
+ /* We'll drive RTS, so no pull */
pins = "gpio39";
drive-strength = <2>;
bias-disable;
};
pinconf-tx {
- /* We'll drive 40 (TX), so no pull */
+ /* We'll drive TX, so no pull */
pins = "gpio40";
drive-strength = <2>;
bias-disable;
- output-high;
};
pinconf-rx {
/*
- * Configure a pull-up on 41 (RX). This is needed to avoid
+ * Configure a pull-up on RX. This is needed to avoid
* garbage data when the TX pin of the Bluetooth module is
* in tri-state (module powered off or not driving the
* signal yet).
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
