Hello The DP83822 Ethernet PHY has the ability to connect via a Fiber port. The derivative PHYs DP83825 and DP83826 do not have this ability. In fiber mode the DP83822 disables auto negotiation and has a fixed 100Mbps speed with support for full or half duplex modes. A devicetree binding was added to set the signal polarity for the fiber connection. This property is only applicable if the FX_EN strap is set in hardware other wise the signal loss detection is disabled on the PHY. If the FX_EN is not strapped the device can be configured to run in fiber mode via the device tree. All be it the PHY will not perform signal loss detection. v2 review from a long time ago can be found here - https://lore.kernel.org/patchwork/patch/1270958/ Dan Dan Murphy (2): dt-bindings: net: dp83822: Add TI dp83822 phy net: phy: DP83822: Add ability to advertise Fiber connection .../devicetree/bindings/net/ti,dp83822.yaml | 80 +++++++ drivers/net/phy/dp83822.c | 225 +++++++++++++++++- 2 files changed, 298 insertions(+), 7 deletions(-) create mode 100644 Documentation/devicetree/bindings/net/ti,dp83822.yaml -- 2.28.0
