Re: [PATCH 3/3] drm/panel: Add panel driver for the Mantix MLAF057WE51-X DSI panel

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sat, Aug 15, 2020 at 12:40:22PM +0200, Guido Günther wrote:
> Hi Sam,
> On Sat, Aug 15, 2020 at 12:02:30PM +0200, Sam Ravnborg wrote:
> > Hi Guido.
> > 
> > > +static int mantix_probe(struct mipi_dsi_device *dsi)
> > > +{
> > > +	struct device *dev = &dsi->dev;
> > > +	struct mantix *ctx;
> > > +	int ret;
> > > +
> > > +	ctx = devm_kzalloc(dev, sizeof(*ctx), GFP_KERNEL);
> > > +	if (!ctx)
> > > +		return -ENOMEM;
> > > +
> > > +	ctx->reset_gpio = devm_gpiod_get(dev, "reset", GPIOD_OUT_LOW);
> > > +	if (IS_ERR(ctx->reset_gpio)) {
> > > +		DRM_DEV_ERROR(dev, "cannot get reset gpio\n");
> > > +		return PTR_ERR(ctx->reset_gpio);
> > > +	}
> > > +
> > > +	mipi_dsi_set_drvdata(dsi, ctx);
> > > +	ctx->dev = dev;
> > > +
> > > +	dsi->lanes = 4;
> > > +	dsi->format = MIPI_DSI_FMT_RGB888;
> > > +	dsi->mode_flags = MIPI_DSI_MODE_VIDEO |
> > > +		MIPI_DSI_MODE_VIDEO_BURST | MIPI_DSI_MODE_VIDEO_SYNC_PULSE;
> > > +
> > > +	ctx->avdd = devm_regulator_get(dev, "avdd");
> > > +	if (IS_ERR(ctx->avdd)) {
> > > +		ret = PTR_ERR(ctx->avdd);
> > > +		if (ret != -EPROBE_DEFER)
> > > +			DRM_DEV_ERROR(dev,
> > > +				      "Failed to request avdd regulator: %d\n",
> > > +				      ret);
> > > +		return ret;
> > > +	}
> > 
> > Consider to use the recently added dev_err_probe() here and below.
> > Note: Not part of drm-misc-next yet - but hopefully after -rc1
> > when a backmerge is done.
> 
> In fact I did decided against it since i was told that missing dev_* and
> DRM_* logging shouldn't be done. So is that o.k. nowadays?
s/missing/mixing/

I often request that logging is consistent - so I recognize the
argument.

For panel/* I have not made up my mind what I think is the best
approach. The DRM_DEV_* and DRM_* logging do not add much value.
So I have been tempted several times to convert all logging in
panel/ to dev_* and pr_* (when no struct device * is available).
That would also avoid that we mix up logging.

We have drm_* logging - but they require a valid drm_device * which we
do not have in the the panel drivers. So they are ruled out here.

Do you have any opinions/comments on this?

	Sam



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux