Hi Ansuel, Thank you for the patience. On 6/16/20 12:05 AM, Ansuel Smith wrote: > This contains multiple fix for PCIe qcom driver. > Some optional reset and clocks were missing. > Fix a problem with no PARF programming that cause kernel lock on load. > Add support to force gen 1 speed if needed. (due to hardware limitation) > Add ipq8064 rev 2 support that use a different tx termination offset. > > v7: > * Rework GEN1 patch > > v6: > * Replace custom define > * Move define not used in 07 to 08 > > v5: > * Split PCI: qcom: Add ipq8064 rev2 variant and set tx term offset > > v4: > * Fix grammar error across all patch subject > * Use bulk api for clks > * Program PARF only in ipq8064 SoC > * Program tx term only in ipq8064 SoC > * Drop configurable tx-dempth rx-eq > * Make added clk optional > > v3: > * Fix check reported by checkpatch --strict > * Rename force_gen1 to gen > > v2: > * Drop iATU programming (already done in pcie init) > * Use max-link-speed instead of force-gen1 custom definition > * Drop MRRS to 256B (Can't find a realy reason why this was suggested) > * Introduce a new variant for different revision of ipq8064 > > Abhishek Sahu (1): > PCI: qcom: Change duplicate PCI reset to phy reset > > Ansuel Smith (10): > PCI: qcom: Add missing ipq806x clocks in PCIe driver > dt-bindings: PCI: qcom: Add missing clks > PCI: qcom: Add missing reset for ipq806x > dt-bindings: PCI: qcom: Add ext reset > PCI: qcom: Use bulk clk api and assert on error > PCI: qcom: Define some PARF params needed for ipq8064 SoC > PCI: qcom: Add support for tx term offset for rev 2.1.0 > PCI: qcom: Add ipq8064 rev2 variant > dt-bindings: PCI: qcom: Add ipq8064 rev 2 variant > PCI: qcom: Replace define with standard value > > Sham Muthayyan (1): > PCI: qcom: Support pci speed set for ipq806x > > .../devicetree/bindings/pci/qcom,pcie.txt | 15 +- > drivers/pci/controller/dwc/pcie-qcom.c | 186 +++++++++++------- > 2 files changed, 128 insertions(+), 73 deletions(-) > For the whole set: Acked-by: Stanimir Varbanov <svarbanov@xxxxxxxxxx> -- regards, Stan
