Previously present pinctrl node didn't show
problems, but I have in fact misconfigured it.
Fix it to actually enable the use of GPIOs.
Signed-off-by: Konrad Dybcio <konradybcio@xxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sdm630.dtsi | 12 ++++++++----
1 file changed, 8 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/sdm630.dtsi b/arch/arm64/boot/dts/qcom/sdm630.dtsi
index 92bf4ae6a590..25c18edcb1fa 100644
--- a/arch/arm64/boot/dts/qcom/sdm630.dtsi
+++ b/arch/arm64/boot/dts/qcom/sdm630.dtsi
@@ -582,14 +582,18 @@ tcsr_mutex_regs: syscon@1f40000 {
reg = <0x01f40000 0x20000>;
};
- tlmm: pinctrl@3000000 {
+ tlmm: pinctrl@3100000 {
compatible = "qcom,sdm630-pinctrl";
- reg = <0x03000000 0xc00000>;
+ reg = <0x03100000 0x400000>,
+ <0x03500000 0x400000>,
+ <0x03900000 0x400000>;
+ reg-names = "south", "center", "north";
interrupts = <GIC_SPI 208 IRQ_TYPE_LEVEL_HIGH>;
gpio-controller;
- #gpio-cells = <0x2>;
+ gpio-ranges = <&tlmm 0 0 114>;
+ #gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <0x2>;
+ #interrupt-cells = <2>;
blsp1_uart1_default: blsp1-uart1-default {
pins = "gpio0", "gpio1", "gpio2", "gpio3";
--
2.27.0
