Hi Benjamin,
thanks for reply.
On Fri, May 15, 2020 at 4:31 PM Benjamin GAIGNARD
<benjamin.gaignard@xxxxxx> wrote:
>
>
>
> On 5/14/20 3:07 PM, dillon min wrote:
> > Hi Alexandre,
> >
> > On Thu, May 14, 2020 at 8:53 PM Alexandre Torgue
> > <alexandre.torgue@xxxxxx> wrote:
> >>
> >>
> >> On 5/14/20 10:24 AM, Linus Walleij wrote:
> >>> On Tue, May 12, 2020 at 9:04 AM <dillon.minfei@xxxxxxxxx> wrote:
> >>>
> >>>> From: dillon min <dillon.minfei@xxxxxxxxx>
> >>>>
> >>>> Enable the ltdc & ili9341 on stm32429-disco board.
> >>>>
> >>>> Signed-off-by: dillon min <dillon.minfei@xxxxxxxxx>
> >>> This mostly looks good but...
> >>>
> >>>> +&spi5 {
> >>>> + status = "okay";
> >>>> + pinctrl-0 = <&spi5_pins>;
> >>>> + pinctrl-names = "default";
> >>>> + #address-cells = <1>;
> >>>> + #size-cells = <0>;
> >>>> + cs-gpios = <&gpioc 2 GPIO_ACTIVE_LOW>;
> >>>> + dmas = <&dma2 3 2 0x400 0x0>,
> >>>> + <&dma2 4 2 0x400 0x0>;
> >>>> + dma-names = "rx", "tx";
> >>> These DMA assignments seem to be SoC things and should
> >>> rather be in the DTS(I) file where &spi5 is defined, right?
> >>> stm32f429.dtsi I suppose?
> >> I agree with Linus, DMA have to be defined in SoC dtsi. And if a board
> >> doesn't want to use it, we use the "delete-property".
> > Yes, will move to Soc dtsi in next submits.
> >
> > i'm working on write a v4l2-m2m driver for dma2d of stm32 to support
> > pixel conversion
> > alpha blending between foreground and background graphics.
> >
> > as you know, some soc's engineer trying to add this function to drm system.
> >
> > do you know st's planning about soc's hardware accelerator driver on stm32mp?
> > such as chrom-art, will add to drm subsystem via ioctl to access, or to v4l2,
> On stm32mp we do not plan to use chrom-art in drm or v4l2 because it
> does fit
> with userland way of working. We use the GPU to do conversion, scaling,
> blending
> and composition in only one go.
> As explain here [1] DRM subsytem it isn't a solution and v4l2-m2m isn't
> used in any
> mainline compositors like Weston or android surfaceflinger.
>
> Benjamin
>
After check stm32mp's datasheets, they don't have chrom-art ip inside. sorry for
didn't check it yet.
for stm32h7 series with chrom-art, jpeg hardware accelerator inside.
does st has plan to
setup a driver to support it ? i prefer v4l2-m2m should be easier to
implement it.
co work with dcmi, fbdev.
thanks.
best regards.
Dillon
> [1]
> https://www.phoronix.com/scan.php?page=news_item&px=Linux-DRM-No-2D-Accel-API
> >
> > thanks.
> >
> >>> It is likely the same no matter which device is using spi5.
> >>>
> >>> Yours,
> >>> Linus Walleij
> >>>
> > _______________________________________________
> > Linux-stm32 mailing list
> > Linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx
> > https://st-md-mailman.stormreply.com/mailman/listinfo/linux-stm32
