Re: [PATCH V6 3/3] dt-bindings: serial: Add binding for UART pin swap

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, May 07, 2020 at 08:30:47PM +0530, Akash Asthana wrote:
> Add documentation to support RX-TX & CTS-RTS GPIO pin swap in HW.
> 
> Signed-off-by: Akash Asthana <akashast@xxxxxxxxxxxxxx>
> ---
>  Documentation/devicetree/bindings/serial/serial.yaml | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/serial/serial.yaml b/Documentation/devicetree/bindings/serial/serial.yaml
> index 53204d9..e657dd6 100644
> --- a/Documentation/devicetree/bindings/serial/serial.yaml
> +++ b/Documentation/devicetree/bindings/serial/serial.yaml
> @@ -67,6 +67,12 @@ properties:
>        (wired and enabled by pinmux configuration).  This depends on both the
>        UART hardware and the board wiring.
>  
> +  rx-tx-swap:
> +    description: RX and TX pins are swapped.
> +
> +  cts-rts-swap:
> +    description: CTS and RTS pins are swapped.

Need 'type: boolean' on both of these.

> +
>  if:
>    required:
>      - uart-has-rtscts
> -- 
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,\na Linux Foundation Collaborative Project



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux