On Mon, May 11, 2020 at 06:44:14PM +0100, Mark Brown wrote: > On Mon, May 11, 2020 at 04:45:02PM +0300, Serge Semin wrote: > > On Mon, May 11, 2020 at 12:58:13PM +0100, Mark Brown wrote: > > > > That sounds like you need to also impose a limit on the maximum message > > > size as well then, with that you should be able to handle messages up > > > to whatever that limit is. There's code for that bit already, so long > > > as the limit is not too low it should be fine for most devices and > > > client drivers can see the limit so they can be updated to work with it > > > if needed. > > > Hmm, this might work. The problem will be with imposing such limitation through > > the DW APB SSI driver. In order to do this I need to know: > > > 1) Whether multi-block LLP is supported by the DW DMA controller. > > 2) Maximum DW DMA transfer block size. > > There is a constraint enumeration interface in the DMA API which you > should be able to extend for this if it doesn't already support what you > need. Yes, that's max segment size. > > > Then I'll be able to use this information in the can_dma() callback to enable > > the DMA xfers only for the safe transfers. Did you mean something like this when > > you said "There's code for that bit already" ? If you meant the max_dma_len > > parameter, then setting it won't work, because it just limits the SG items size > > not the total length of a single transfer. > > You can set max_transfer_size and/or max_message_size in the SPI driver > - you should be able to do this on probe. Thanks for the explanation. Max segment size being set to the DMA controller generic device should work well. There is no need in setting the transfer and messages size limitations. Besides I don't really see the max_transfer_size/max_message_size callbacks utilized in the SPI core. These functions are called in the spi-mem.c driver only. Do I miss something? -Sergey
