Re: [PATCH v8 4/5] usb: ehci: Add new EHCI driver for Broadcom STB SoC's

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, 8 May 2020, Al Cooper wrote:

A few minor typos in the patch description:

> Add a new EHCI driver for Broadcom STB SoC's. A new EHCI driver
> was created instead of adding support to the existing ehci platform
> driver because of the code required to workaround bugs in the EHCI
-----------------------------------------^

"workaround" is a noun; the verb form is "work around".

> controller. The primary workround is for a bug where the Core
-----------------------------^

Missing "a".

> violates the SOF interval between the first two SOFs transmitted after
> resume. This only happens if the resume occurs near the end of a
> microframe. The fix is to intercept the echi-hcd request to complete
-------------------------------------------^

ehci, not echi.

> RESUME and align it to the start of the next microframe.
> 
> Signed-off-by: Al Cooper <alcooperx@xxxxxxxxx>
> Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>
> ---

Basically this new driver is fine.  However...

> +static inline void ehci_brcm_wait_for_sof(struct ehci_hcd *ehci, u32 delay)
> +{
> +	u32 frame_idx = ehci_readl(ehci, &ehci->regs->frame_index);
> +	u32 val;
> +	int res;
> +
> +	/* Wait for next microframe (every 125 usecs) */
> +	res = readl_relaxed_poll_timeout(&ehci->regs->frame_index, val,
> +					 val != frame_idx, 1, 130);
> +	if (res)
> +		dev_err(ehci_to_hcd(ehci)->self.controller,
> +			"Error waiting for SOF\n");

If this patch is going to be redone anyway, you might as well change
dev_err() to ehci_err() -- that's what it's for.  I should have noticed
this earlier, sorry.

> +static int ehci_brcm_probe(struct platform_device *pdev)
> +{
> +	struct device *dev = &pdev->dev;
> +	struct resource *res_mem;
> +	struct brcm_priv *priv;
> +	struct usb_hcd *hcd;
> +	int irq;
> +	int err;
> +
> +	err = dma_set_mask_and_coherent(dev, DMA_BIT_MASK(32));
> +	if (err)
> +		return err;
> +
> +	irq = platform_get_irq(pdev, 0);
> +	if (irq <= 0)
> +		return irq;

I don't want to get involved in the question of whether or not 0 is a 
valid IRQ number.  The consensus has gone back and forth over the 
years, and it just doesn't seem important.

However, as Sergei points out, if 0 is going to be regarded as an 
invalid value then we shouldn't return 0 from the probe function here.

I'll leave the decision on how to handle this matter up to Greg.  :-)

Alan Stern






[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux