Hi Maxime,
On Thu, 30 Apr 2020 at 10:46, Maxime Ripard <maxime@xxxxxxxxxx> wrote:
>
> Hi,
>
> On Wed, Apr 29, 2020 at 06:33:00PM +0200, Clément Péron wrote:
> > On Wed, 29 Apr 2020 at 14:35, Maxime Ripard <maxime@xxxxxxxxxx> wrote:
> > >
> > > On Tue, Apr 28, 2020 at 10:55:47AM +0200, Clément Péron wrote:
> > > > > > +static int sun50i_i2s_set_soc_fmt(const struct sun4i_i2s *i2s,
> > > > > > + unsigned int fmt)
> > > > >
> > > > > The alignment is off here
> > > > >
> > > > > > +{
> > > > > > + u32 mode, val;
> > > > > > + u8 offset;
> > > > > > +
> > > > > > + /*
> > > > > > + * DAI clock polarity
> > > > > > + *
> > > > > > + * The setup for LRCK contradicts the datasheet, but under a
> > > > > > + * scope it's clear that the LRCK polarity is reversed
> > > > > > + * compared to the expected polarity on the bus.
> > > > > > + */
> > > > >
> > > > > Did you check this or has it been copy-pasted?
> > > >
> > > > copy-pasted, I will check this.
> > >
> > > It's not going to be easy to do this if you only have a board with HDMI. If you
> > > can't test that easily, just remove the comment (or make it explicit that you
> > > copy pasted it?), no comment is better than a wrong one.
> >
> > I have talked with Marcus Cooper it may be able to test this this week-end.
> > Also this can explain why we need the "
> > simple-audio-card,frame-inversion;" in the device-tree.
> >
> > If think this fix has been introduced by you, correct? Could you say
> > on which SoC did you see this issue?
>
> This was seen on an H3
Just two more questions:
- Did you observe this issue on both TDM and I2S mode?
- On which DAI node?
Since recent change in sun4i-i2s.c, we had to introduce the
"simple-audio-card,frame-inversion" in LibreElec tree.
H3 boards are quite common in LibreElec community so I think:
- This fix is only needed in TDM mode
- Or this fix is not required for the HDMI DAI node (HDMI DAI is a
little bit different compare to other DAI but I think the first guess
is more likely)
Regards,
Clement
>
> Maxime
