Document the ADIS16475 device devicetree bindings Signed-off-by: Nuno Sá <nuno.sa@xxxxxxxxxx> --- Changes in v2: * Remove burst32 property; * Rename clk-mode to adi,sync-mode; * Remove clock-names; * Add conditionals to state that clocks is only needed depending on adi,sync-mode property. Changes in v3: * Make use of 'allOf' in conditionals. Changes in v4: * Nothing changed. Changes in v5: * Nothing changed. .../bindings/iio/imu/adi,adis16475.yaml | 137 ++++++++++++++++++ MAINTAINERS | 1 + 2 files changed, 138 insertions(+) create mode 100644 Documentation/devicetree/bindings/iio/imu/adi,adis16475.yaml diff --git a/Documentation/devicetree/bindings/iio/imu/adi,adis16475.yaml b/Documentation/devicetree/bindings/iio/imu/adi,adis16475.yaml new file mode 100644 index 000000000000..98baecb4b98a --- /dev/null +++ b/Documentation/devicetree/bindings/iio/imu/adi,adis16475.yaml @@ -0,0 +1,137 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/iio/imu/adi,adis16475.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Analog Devices ADIS16475 and similar IMUs + +maintainers: + - Nuno Sá <nuno.sa@xxxxxxxxxx> + +description: | + Analog Devices ADIS16475 and similar IMUs + https://www.analog.com/media/en/technical-documentation/data-sheets/ADIS16475.pdf + +properties: + compatible: + enum: + - adi,adis16475-1 + - adi,adis16475-2 + - adi,adis16475-3 + - adi,adis16477-1 + - adi,adis16477-2 + - adi,adis16477-3 + - adi,adis16470 + - adi,adis16465-1 + - adi,adis16465-2 + - adi,adis16465-3 + - adi,adis16467-1 + - adi,adis16467-2 + - adi,adis16467-3 + - adi,adis16500 + - adi,adis16505-1 + - adi,adis16505-2 + - adi,adis16505-3 + - adi,adis16507-1 + - adi,adis16507-2 + - adi,adis16507-3 + + reg: + maxItems: 1 + + spi-cpha: true + + spi-cpol: true + + spi-max-frequency: + maximum: 2000000 + + interrupts: + maxItems: 1 + + clocks: + maxItems: 1 + + reset-gpios: + description: + Must be the device tree identifier of the RESET pin. If specified, + it will be asserted during driver probe. As the line is active low, + it should be marked GPIO_ACTIVE_LOW. + maxItems: 1 + + adi,sync-mode: + description: + Configures the device SYNC pin. The following modes are supported + 0 - output_sync + 1 - direct_sync + 2 - scaled_sync + 3 - pulse_sync + allOf: + - $ref: /schemas/types.yaml#/definitions/uint32 + minimum: 0 + maximum: 3 + + adi,scaled-output-hz: + description: + This property must be present if the clock mode is scaled-sync through + clock-names property. In this mode, the input clock can have a range + of 1Hz to 128HZ which must be scaled to originate an allowable sample + rate. This property specifies that rate. + minimum: 1900 + maximum: 2100 + +required: + - compatible + - reg + - interrupts + - spi-cpha + - spi-cpol + +allOf: + - if: + properties: + compatible: + contains: + enum: + - adi,adis16500 + - adi,adis16505-1 + - adi,adis16505-2 + - adi,adis16505-3 + - adi,adis16507-1 + - adi,adis16507-2 + - adi,adis16507-3 + + then: + properties: + adi,sync-mode: + minimum: 0 + maximum: 2 + + - if: + properties: + adi,sync-mode: + enum: [1, 2, 3] + + then: + dependencies: + adi,sync-mode: [ clocks ] + +examples: + - | + #include <dt-bindings/interrupt-controller/irq.h> + spi { + #address-cells = <1>; + #size-cells = <0>; + + adis16475: adis16475-3@0 { + compatible = "adi,adis16475-3"; + reg = <0>; + spi-cpha; + spi-cpol; + spi-max-frequency = <2000000>; + interrupts = <4 IRQ_TYPE_EDGE_RISING>; + interrupt-parent = <&gpio>; + }; + }; +... diff --git a/MAINTAINERS b/MAINTAINERS index a2ff8322c184..0828302accd8 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -1015,6 +1015,7 @@ L: linux-iio@xxxxxxxxxxxxxxx W: http://ez.analog.com/community/linux-device-drivers S: Supported F: drivers/iio/imu/adis16475.c +F: Documentation/devicetree/bindings/iio/imu/adi,adis16475.yaml ANALOG DEVICES INC ADM1177 DRIVER M: Beniamin Bia <beniamin.bia@xxxxxxxxxx> -- 2.17.1
