Hi Prabhakar, Thank you for the patch. On Mon, Apr 06, 2020 at 05:42:37PM +0100, Lad Prabhakar wrote: > OV5645 sensor supports input clock frequency ranging from 6MHz to 27MHz > but the driver strictly expects this to be 24MHz (with tolerance of 1%) > with this restrictions let the driver enforce the clock frequency Maybe s/with/With/ ? > internally to 24MHz rather then being passed as dt-property. > > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> Reviewed-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx> > --- > Documentation/devicetree/bindings/media/i2c/ov5645.txt | 2 -- > 1 file changed, 2 deletions(-) > > diff --git a/Documentation/devicetree/bindings/media/i2c/ov5645.txt b/Documentation/devicetree/bindings/media/i2c/ov5645.txt > index 72ad992f77be..a55bb728ea48 100644 > --- a/Documentation/devicetree/bindings/media/i2c/ov5645.txt > +++ b/Documentation/devicetree/bindings/media/i2c/ov5645.txt > @@ -8,7 +8,6 @@ Required Properties: > - compatible: Value should be "ovti,ov5645". > - clocks: Reference to the xclk clock. > - clock-names: Should be "xclk". > -- clock-frequency: Frequency of the xclk clock. > - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds > to the hardware pin PWDNB which is physically active low. > - reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to > @@ -37,7 +36,6 @@ Example: > > clocks = <&clks 200>; > clock-names = "xclk"; > - clock-frequency = <24000000>; > > vdddo-supply = <&camera_dovdd_1v8>; > vdda-supply = <&camera_avdd_2v8>; -- Regards, Laurent Pinchart
