From: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
Add Force GEN1 support needed in some ipq806x board
that needs to limit some pcie line to gen1 for some
hardware limitation.
This is set by the max-link-speed dts entry and needed
by some soc based on ipq806x. (for example Netgear R7800
router)
Signed-off-by: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
---
drivers/pci/controller/dwc/pcie-qcom.c | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 8047ac7dc8c7..2212e9498b91 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -27,6 +27,7 @@
#include <linux/slab.h>
#include <linux/types.h>
+#include "../../pci.h"
#include "pcie-designware.h"
#define PCIE20_PARF_SYS_CTRL 0x00
@@ -99,6 +100,8 @@
#define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE 0x358
#define SLV_ADDR_SPACE_SZ 0x10000000
+#define PCIE20_LNK_CONTROL2_LINK_STATUS2 0xA0
+
#define DEVICE_TYPE_RC 0x4
#define QCOM_PCIE_2_1_0_MAX_SUPPLY 3
@@ -199,6 +202,7 @@ struct qcom_pcie {
struct phy *phy;
struct gpio_desc *reset;
const struct qcom_pcie_ops *ops;
+ bool force_gen1;
};
#define to_qcom_pcie(x) dev_get_drvdata((x)->dev)
@@ -441,6 +445,11 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
/* wait for clock acquisition */
usleep_range(1000, 1500);
+ if (pcie->force_gen1) {
+ writel_relaxed((readl_relaxed(
+ pcie->pci->dbi_base + PCIE20_LNK_CONTROL2_LINK_STATUS2) | 1),
+ pcie->pci->dbi_base + PCIE20_LNK_CONTROL2_LINK_STATUS2);
+ }
/* Set the Max TLP size to 2K, instead of using default of 4K */
@@ -1440,6 +1449,10 @@ static int qcom_pcie_probe(struct platform_device *pdev)
goto err_pm_runtime_put;
}
+ ret = of_pci_get_max_link_speed(pdev->dev.of_node);
+ if (ret == 1)
+ pcie->force_gen1 = true;
+
res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "parf");
pcie->parf = devm_ioremap_resource(dev, res);
if (IS_ERR(pcie->parf)) {
--
2.25.1
