On Fri 20 Mar 11:34 PDT 2020, Ansuel Smith wrote:
> From: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
>
> Add tx term offset support to pcie qcom driver
> need in some revision of the ipq806x soc
>
> Signed-off-by: Sham Muthayyan <smuthayy@xxxxxxxxxxxxxx>
> Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
> ---
> drivers/pci/controller/dwc/pcie-qcom.c | 61 ++++++++++++++++++++++----
> 1 file changed, 52 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index ecc22fd27ea6..8009e3117765 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -45,7 +45,13 @@
> #define PCIE_CAP_CPL_TIMEOUT_DISABLE 0x10
>
> #define PCIE20_PARF_PHY_CTRL 0x40
> +#define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK (0x1f << 16)
> +#define PHY_CTRL_PHY_TX0_TERM_OFFSET(x) (x << 16)
> +
> #define PCIE20_PARF_PHY_REFCLK 0x4C
> +#define REF_SSP_EN BIT(16)
> +#define REF_USE_PAD BIT(12)
> +
> #define PCIE20_PARF_DBI_BASE_ADDR 0x168
> #define PCIE20_PARF_SLV_ADDR_SPACE_SIZE 0x16C
> #define PCIE20_PARF_MHI_CLOCK_RESET_CTRL 0x174
> @@ -77,6 +83,18 @@
> #define DBI_RO_WR_EN 1
>
> #define PERST_DELAY_US 1000
> +/* PARF registers */
> +#define PCIE20_PARF_PCS_DEEMPH 0x34
> +#define PCS_DEEMPH_TX_DEEMPH_GEN1(x) (x << 16)
> +#define PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(x) (x << 8)
> +#define PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(x) (x << 0)
> +
> +#define PCIE20_PARF_PCS_SWING 0x38
> +#define PCS_SWING_TX_SWING_FULL(x) (x << 8)
> +#define PCS_SWING_TX_SWING_LOW(x) (x << 0)
> +
> +#define PCIE20_PARF_CONFIG_BITS 0x50
> +#define PHY_RX0_EQ(x) (x << 24)
>
> #define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE 0x358
> #define SLV_ADDR_SPACE_SZ 0x10000000
> @@ -97,6 +115,7 @@ struct qcom_pcie_resources_2_1_0 {
> struct reset_control *phy_reset;
> struct reset_control *ext_reset;
> struct regulator_bulk_data supplies[QCOM_PCIE_2_1_0_MAX_SUPPLY];
> + uint8_t phy_tx0_term_offset;
> };
>
> struct qcom_pcie_resources_1_0_0 {
> @@ -184,6 +203,16 @@ struct qcom_pcie {
>
> #define to_qcom_pcie(x) dev_get_drvdata((x)->dev)
>
> +static inline void
> +writel_masked(void __iomem *addr, u32 clear_mask, u32 set_mask)
> +{
> + u32 val = readl(addr);
> +
> + val &= ~clear_mask;
> + val |= set_mask;
> + writel(val, addr);
> +}
> +
> static void qcom_ep_reset_assert(struct qcom_pcie *pcie)
> {
> gpiod_set_value_cansleep(pcie->reset, 1);
> @@ -277,6 +306,10 @@ static int qcom_pcie_get_resources_2_1_0(struct qcom_pcie *pcie)
> if (IS_ERR(res->ext_reset))
> return PTR_ERR(res->ext_reset);
>
> + if (of_property_read_u8(dev->of_node, "phy-tx0-term-offset",
> + &res->phy_tx0_term_offset))
> + res->phy_tx0_term_offset = 0;
The appropriate way is to encode differences in hardware is to use
different compatibles for the two different versions of the hardware.
Regards,
Bjorn
> +
> res->phy_reset = devm_reset_control_get_exclusive(dev, "phy");
> return PTR_ERR_OR_ZERO(res->phy_reset);
> }
> @@ -304,7 +337,6 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
> struct qcom_pcie_resources_2_1_0 *res = &pcie->res.v2_1_0;
> struct dw_pcie *pci = pcie->pci;
> struct device *dev = pci->dev;
> - u32 val;
> int ret;
>
> ret = reset_control_assert(res->ahb_reset);
> @@ -355,15 +387,26 @@ static int qcom_pcie_init_2_1_0(struct qcom_pcie *pcie)
> goto err_deassert_ahb;
> }
>
> - /* enable PCIe clocks and resets */
> - val = readl(pcie->parf + PCIE20_PARF_PHY_CTRL);
> - val &= ~BIT(0);
> - writel(val, pcie->parf + PCIE20_PARF_PHY_CTRL);
> + writel_masked(pcie->parf + PCIE20_PARF_PHY_CTRL, BIT(0), 0);
> +
> + /* Set Tx termination offset */
> + writel_masked(pcie->parf + PCIE20_PARF_PHY_CTRL,
> + PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK,
> + PHY_CTRL_PHY_TX0_TERM_OFFSET(res->phy_tx0_term_offset));
> +
> + /* PARF programming */
> + writel(PCS_DEEMPH_TX_DEEMPH_GEN1(0x18) |
> + PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(0x18) |
> + PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(0x22),
> + pcie->parf + PCIE20_PARF_PCS_DEEMPH);
> + writel(PCS_SWING_TX_SWING_FULL(0x78) |
> + PCS_SWING_TX_SWING_LOW(0x78),
> + pcie->parf + PCIE20_PARF_PCS_SWING);
> + writel(PHY_RX0_EQ(0x4), pcie->parf + PCIE20_PARF_CONFIG_BITS);
>
> - /* enable external reference clock */
> - val = readl(pcie->parf + PCIE20_PARF_PHY_REFCLK);
> - val |= BIT(16);
> - writel(val, pcie->parf + PCIE20_PARF_PHY_REFCLK);
> + /* Enable reference clock */
> + writel_masked(pcie->parf + PCIE20_PARF_PHY_REFCLK,
> + REF_USE_PAD, REF_SSP_EN);
>
> ret = reset_control_deassert(res->phy_reset);
> if (ret) {
> --
> 2.25.1
>
