From: Vladimir Oltean <vladimir.oltean@xxxxxxx> The SPI_MCR_PCSIS macro assumes that the controller has a number of chip select signals equal to 6. That is not always the case, but actually is described through the driver-specific "spi-num-chipselects" device tree binding. LS1028A for example only has 4 chip selects. Don't write to the upper bits of the PCSIS field, which are reserved in the reference manual. Fixes: 349ad66c0ab0 ("spi:Add Freescale DSPI driver for Vybrid VF610 platform") Signed-off-by: Vladimir Oltean <vladimir.oltean@xxxxxxx> --- Changes in v5: None. Changes in v4: None. Changes in v3: None. Changes in v2: Remove duplicate phrase in commit message. drivers/spi/spi-fsl-dspi.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/drivers/spi/spi-fsl-dspi.c b/drivers/spi/spi-fsl-dspi.c index 50e3382f0c50..6ca35881881b 100644 --- a/drivers/spi/spi-fsl-dspi.c +++ b/drivers/spi/spi-fsl-dspi.c @@ -22,7 +22,7 @@ #define SPI_MCR 0x00 #define SPI_MCR_MASTER BIT(31) -#define SPI_MCR_PCSIS (0x3F << 16) +#define SPI_MCR_PCSIS(x) ((x) << 16) #define SPI_MCR_CLR_TXF BIT(11) #define SPI_MCR_CLR_RXF BIT(10) #define SPI_MCR_XSPI BIT(3) @@ -1200,7 +1200,10 @@ static const struct regmap_config dspi_xspi_regmap_config[] = { static void dspi_init(struct fsl_dspi *dspi) { - unsigned int mcr = SPI_MCR_PCSIS; + unsigned int mcr; + + /* Set idle states for all chip select signals to high */ + mcr = SPI_MCR_PCSIS(GENMASK(dspi->ctlr->num_chipselect - 1, 0)); if (dspi->devtype_data->trans_mode == DSPI_XSPI_MODE) mcr |= SPI_MCR_XSPI; -- 2.17.1