Use assigned-clock-rates to specify the clock rate. Also mark clock-frequency property as deprecated. Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/media/i2c/ov5645.txt | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/Documentation/devicetree/bindings/media/i2c/ov5645.txt b/Documentation/devicetree/bindings/media/i2c/ov5645.txt index 72ad992..e62fe82 100644 --- a/Documentation/devicetree/bindings/media/i2c/ov5645.txt +++ b/Documentation/devicetree/bindings/media/i2c/ov5645.txt @@ -8,7 +8,7 @@ Required Properties: - compatible: Value should be "ovti,ov5645". - clocks: Reference to the xclk clock. - clock-names: Should be "xclk". -- clock-frequency: Frequency of the xclk clock. +- clock-frequency (deprecated): Frequency of the xclk clock. - enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds to the hardware pin PWDNB which is physically active low. - reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to @@ -37,7 +37,8 @@ Example: clocks = <&clks 200>; clock-names = "xclk"; - clock-frequency = <24000000>; + assigned-clocks = <&clks 200>; + assigned-clock-rates = <24000000>; vdddo-supply = <&camera_dovdd_1v8>; vdda-supply = <&camera_avdd_2v8>; -- 2.7.4
