On Fri, Mar 13, 2020 at 10:15:44AM -0400, Al Cooper wrote:
> Add a new EHCI driver for Broadcom STB SoC's. A new EHCI driver
> was created instead of adding support to the existing ehci platform
> driver because of the code required to workaround bugs in the EHCI
> controller.
I'm not sure this is the best approach, but I leave it to maintainers.
By the way, can you list what exactly the difference to the (generic)
ehci driver?
...
> +#include <linux/acpi.h>
> +#include <linux/clk.h>
> +#include <linux/dma-mapping.h>
> +#include <linux/err.h>
> +#include <linux/kernel.h>
> +#include <linux/io.h>
> +#include <linux/module.h>
> +#include <linux/of.h>
> +#include <linux/platform_device.h>
...
> +/* ehci_brcm_wait_for_sof
> + * Wait for start of next microframe, then wait extra delay microseconds
> + */
Style is inconsistent even inside this file.
> +static inline void ehci_brcm_wait_for_sof(struct ehci_hcd *ehci, u32 delay)
> +{
> + int frame_idx = ehci_readl(ehci, &ehci->regs->frame_index);
This is not needed if you use do {} while approach.
> +
> + while (frame_idx == ehci_readl(ehci, &ehci->regs->frame_index))
> + ;
Busy loop without even power management taking into consideration?
Infinite loop?
> + udelay(delay);
> +}
...
> +static const struct ehci_driver_overrides brcm_overrides __initconst = {
> +
> + .reset = ehci_brcm_reset,
Indentation issue.
> + .extra_priv_size = sizeof(struct brcm_priv),
> +};
...
> +static int ehci_brcm_probe(struct platform_device *pdev)
> +{
> + irq = platform_get_irq(pdev, 0);
> + if (irq < 0) {
> + dev_err(&pdev->dev, "no irq provided");
Duplicate with core message.
> + return irq;
> + }
> + /* initialize hcd */
> + hcd = usb_create_hcd(&ehci_brcm_hc_driver,
> + &pdev->dev, dev_name(&pdev->dev));
At least this one will look much better (and fit one line) when you introduce
struct device *dev = &pdev->dev;
in the definition block above.
> + if (!hcd)
> + return -ENOMEM;
> + return err;
> +}
...
> +static struct platform_driver ehci_brcm_driver = {
> + .probe = ehci_brcm_probe,
> + .remove = ehci_brcm_remove,
> + .shutdown = usb_hcd_platform_shutdown,
> + .driver = {
> + .owner = THIS_MODULE,
Do we need this?
> + .name = "ehci-brcm",
> + .pm = &ehci_brcm_pm_ops,
> + .of_match_table = brcm_ehci_of_match,
> + }
> +};
--
With Best Regards,
Andy Shevchenko
