Hi Vivek,
The 'power-led' need some changes.
>From leds-gpio.yaml:
patternProperties:
# The first form is preferred, but fall back to just 'led' anywhere in the
# node name to at least catch some child nodes.
"(^led-[0-9a-f]$|led)":
type: object
Test with:
make -k ARCH=arm64 dtbs_check
arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dt.yaml: leds:
power-led:linux,default-trigger:0: 'none' is not one of ['backlight',
'default-on', 'heartbeat', 'disk-activity', 'ide-disk', 'timer', 'pattern']
On 3/13/20 1:01 AM, Vivek Unune wrote:
> - Add Hugsun X99 IR receiver and power led
> - Remove pwm0 node as it interferes with pwer LED gpio
pwer => power
> Also, it's not used in factory firmware
>
> Tested with Libreelec kernel v5.6
Test with linux-next.
git clone -- depth 1
https://git.kernel.org/pub/scm/linux/kernel/git/next/linux-next.git
>
> Signed-off-by: Vivek Unune <npcomplete13@xxxxxxxxx>
> ---
> .../boot/dts/rockchip/rk3399-hugsun-x99.dts | 37 +++++++++++++++++--
> 1 file changed, 33 insertions(+), 4 deletions(-)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts b/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
> index d69a613fb65a..df425e164a2e 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-hugsun-x99.dts
> @@ -29,6 +29,26 @@
> regulator-max-microvolt = <5000000>;
> };
>
> + ir-receiver {
> + compatible = "gpio-ir-receiver";
> + gpios = <&gpio0 RK_PA6 GPIO_ACTIVE_LOW>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&ir_rx>;
> + };
> +
> + leds {
> + compatible = "gpio-leds";
> + pinctrl-names = "default";
> + pinctrl-0 = <&power_led_gpio>;
> +
> + power-led {
> + label = "blue:power";
> + gpios = <&gpio4 RK_PC2 GPIO_ACTIVE_HIGH>;
> + default-state = "on";
> + linux,default-trigger = "none";
> + };
> + };
> +
> vcc_sys: vcc-sys {
> compatible = "regulator-fixed";
> regulator-name = "vcc_sys";
> @@ -483,6 +503,18 @@
> };
> };
>
> + ir {
> + ir_rx: ir-rx {
> + rockchip,pins = <0 RK_PA6 1 &pcfg_pull_none>;
> + };
> + };
> +
> + leds {
> + power_led_gpio: power-led-gpio {
> + rockchip,pins = <4 RK_PC2 RK_FUNC_GPIO &pcfg_pull_none>;
> + };
> + };
> +
> pmic {
> pmic_int_l: pmic-int-l {
> rockchip,pins =
> @@ -539,10 +572,6 @@
> };
> };
>
> -&pwm0 {
> - status = "okay";
> -};
> -
> &pwm2 {
> status = "okay";
> pinctrl-0 = <&pwm2_pin_pull_down>;
>
