* reordered patches and send Fixes as separate ones (requested by Thomas Bogendoerfer <tsbogend@xxxxxxxxxxxxxxxx>) * fixed Checkpatch issue with comments in PMU patch (suggested by Thomas Bogendoerfer <tsbogend@xxxxxxxxxxxxxxxx>) PATCH V5 2020-02-29 20:45:52: * add #include irq.h not in PMU patch but in RTC patch * added Reviewed-by: Paul Cercueil <paul@xxxxxxxxxxxxxxx> PATCH V4 2020-02-28 19:02:57: * use KEY_F13 for SW1 button to avoid conflict with Enter of an USB keyboard (suggested by Paul Cercueil <paul@xxxxxxxxxxxxxxx>) * tidy up all new #includes to be at beginning of file and alphabetically sorted (suggested by Paul Cercueil <paul@xxxxxxxxxxxxxxx>) * add new #include to DTS only when needed (suggested by Paul Cercueil <paul@xxxxxxxxxxxxxxx>) PATCH V3 2020-02-16 21:21:07: * dropped "drm: ingenic-drm: add MODULE_DEVICE_TABLE" because it will be resubmitted with a HDMI driver solution * added Cc: stable@xxxxxxxxxxxxxxx where appropriate (suggested by Paul Cercueil <paul@xxxxxxxxxxxxxxx>) * squashed all other DTS and CONFIG changes into single patches (suggested by Paul Cercueil <paul@xxxxxxxxxxxxxxx>) PATCH V2 2020-02-14 17:10:33: * dropped "net: davicom: dm9000: allow to pass MAC address through mac_addr module parameter" from this series because it goes through the netdev tree (suggested by Andrew Lunn <andrew@xxxxxxx>) * added a "fixes:" for "MIPS: DTS: CI20: fix PMU definitions for ACT8600" and "MIPS: DTS: CI20: fix interrupt for pcf8563 RTC" (suggested by Andreas Kemnade <andreas@xxxxxxxxxxxx>) * "i2c: jz4780: silence log flood on txabrt" dropped because it is replaced by a new version in v5.6 by Wolfram Sang <wsa@xxxxxxxxxxxxx> PATCH V1 2020-02-11 22:41:43: This patch set provides several improvements for the CI20 board: * suppress warnings from i2c if device is not responding * make ingenic-drm found through DT * allow davicom dm9000 ethernet controller to use MAC address provided by U-Boot * fix #include in jz4780.dtsi * configure for loadable kernel modules * add DTS for IR sensor and SW1 button * configure so that LEDs, IR sensor, SW1 button have drivers * fix DTS for ACT8600 PMU and configure driver * fix interrupt of nxp,pcf8563 There is another patch set in our queue to add HDMI support on top of this work. Signed-off-by: Paul Boddie <paul@xxxxxxxxxxxxx> Signed-off-by: H. Nikolaus Schaller <hns@xxxxxxxxxxxxx> Alex Smith (1): MIPS: DTS: CI20: add DT node for IR sensor H. Nikolaus Schaller (2): MIPS: DTS: CI20: multiple DTS improvements MIPS: CI20: defconfig: multiple improvements arch/mips/boot/dts/ingenic/ci20.dts | 19 +++++++++++++++++++ arch/mips/configs/ci20_defconfig | 21 +++++++++++++++++++++ 2 files changed, 40 insertions(+) -- 2.23.0
