1.Change the name of power, fault and rear-id.
2.Remove the two leds.
Signed-off-by: Ben Pai <Ben_Pai@xxxxxxxxxxx>
---
arch/arm/boot/dts/aspeed-bmc-opp-mihawk.dts | 17 +++--------------
1 file changed, 3 insertions(+), 14 deletions(-)
diff --git a/arch/arm/boot/dts/aspeed-bmc-opp-mihawk.dts b/arch/arm/boot/dts/aspeed-bmc-opp-mihawk.dts
index e55cc454b17f..6c11854b9006 100644
--- a/arch/arm/boot/dts/aspeed-bmc-opp-mihawk.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-opp-mihawk.dts
@@ -120,35 +120,24 @@
leds {
compatible = "gpio-leds";
- fault {
+ front-fault {
retain-state-shutdown;
default-state = "keep";
gpios = <&gpio ASPEED_GPIO(AA, 0) GPIO_ACTIVE_LOW>;
};
- power {
+ power-button {
retain-state-shutdown;
default-state = "keep";
gpios = <&gpio ASPEED_GPIO(AA, 1) GPIO_ACTIVE_LOW>;
};
- rear-id {
+ front-id {
retain-state-shutdown;
default-state = "keep";
gpios = <&gpio ASPEED_GPIO(AA, 2) GPIO_ACTIVE_LOW>;
};
- rear-g {
- retain-state-shutdown;
- default-state = "keep";
- gpios = <&gpio ASPEED_GPIO(AA, 4) GPIO_ACTIVE_LOW>;
- };
-
- rear-ok {
- retain-state-shutdown;
- default-state = "keep";
- gpios = <&gpio ASPEED_GPIO(Y, 0) GPIO_ACTIVE_LOW>;
- };
fan0 {
retain-state-shutdown;
--
2.17.1
---------------------------------------------------------------------------------------------------------------------------------------------------------------
This email contains confidential or legally privileged information and is for the sole use of its intended recipient.
Any unauthorized review, use, copying or distribution of this email or the content of this email is strictly prohibited.
If you are not the intended recipient, you may reply to the sender and should delete this e-mail immediately.
---------------------------------------------------------------------------------------------------------------------------------------------------------------
