This patch set the correct value for oversampling maxItems. In the
original example, appears 3 items for oversampling while the maxItems
is set to 1, this patch fixes those issues.
Fixes: 416f882c3b40 ("dt-bindings: iio: adc: Migrate AD7606 documentation to yaml")
Signed-off-by: Beniamin Bia <beniamin.bia@xxxxxxxxxx>
---
Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml
index 6eb33207a167..5117ad68a584 100644
--- a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml
+++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml
@@ -82,7 +82,7 @@ properties:
Must be the device tree identifier of the over-sampling
mode pins. As the line is active high, it should be marked
GPIO_ACTIVE_HIGH.
- maxItems: 1
+ maxItems: 3
adi,sw-mode:
description:
@@ -125,9 +125,9 @@ examples:
adi,conversion-start-gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
reset-gpios = <&gpio 27 GPIO_ACTIVE_HIGH>;
adi,first-data-gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
- adi,oversampling-ratio-gpios = <&gpio 18 GPIO_ACTIVE_HIGH
- &gpio 23 GPIO_ACTIVE_HIGH
- &gpio 26 GPIO_ACTIVE_HIGH>;
+ adi,oversampling-ratio-gpios = <&gpio 18 GPIO_ACTIVE_HIGH>,
+ <&gpio 23 GPIO_ACTIVE_HIGH>,
+ <&gpio 26 GPIO_ACTIVE_HIGH>;
standby-gpios = <&gpio 24 GPIO_ACTIVE_LOW>;
adi,sw-mode;
};
--
2.17.1
