Now that the i2c-bcm-iproc driver has been fixed to permit reading more
than 63 bytes in a single transaction with commit fd01eecdf959 ("i2c:
iproc: Fix i2c master read more than 63 bytes") we no longer need to
bitbang i2c over GPIOs which was necessary before to allow the
PHYLINK/SFP subsystems to read SFP modules.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
arch/arm/boot/dts/bcm958625hr.dts | 15 +++++----------
1 file changed, 5 insertions(+), 10 deletions(-)
diff --git a/arch/arm/boot/dts/bcm958625hr.dts b/arch/arm/boot/dts/bcm958625hr.dts
index a2c9de35ddfb..536fb24f38bb 100644
--- a/arch/arm/boot/dts/bcm958625hr.dts
+++ b/arch/arm/boot/dts/bcm958625hr.dts
@@ -55,18 +55,9 @@
priority = <200>;
};
- /* Hardware I2C block cannot do more than 63 bytes per transfer,
- * which would prevent reading from a SFP's EEPROM (256 byte).
- */
- i2c1: i2c {
- compatible = "i2c-gpio";
- sda-gpios = <&gpioa 5 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
- scl-gpios = <&gpioa 4 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
- };
-
sfp: sfp {
compatible = "sff,sfp";
- i2c-bus = <&i2c1>;
+ i2c-bus = <&i2c0>;
mod-def0-gpios = <&gpioa 28 GPIO_ACTIVE_LOW>;
los-gpios = <&gpioa 24 GPIO_ACTIVE_HIGH>;
tx-fault-gpios = <&gpioa 30 GPIO_ACTIVE_HIGH>;
@@ -74,6 +65,10 @@
};
};
+&i2c0 {
+ status = "okay";
+};
+
&amac0 {
status = "okay";
};
--
2.17.1
