Hi, This series enables the 2 USB ports on the DRA7-evm. NOTE: USB1 port is hard coded to work in peripheral mode and USB2 port in host mode. This is due to missing ID pin interrupt in pre ver.E boards. USB1 port doesn't in peripheral mode out of the box due to missing VBUS detection and mailbox write. To test this I had to do a manual write to enable VBUSVALID in the USB_UTMI_OTG_STATUS register. omapconf set bit 0x48880084 1 USB2 port works well in host mode. Patches are based on 3.15-rc3. cheers, -roger Changelog: v3: -Rearraged patches. PHY related stuff first. -Addressed backward compatibility issue for phy-omap-usb2. v2: -Rebased on v3.15-rc3 --- Roger Quadros (7): phy: omap-usb2: Use generic clock names "wkupclk" and "refclk" phy: omap-usb2: Add clock names to Documentation binding ARM: dts: omap4+: Add clocks to USB2 PHY node ARM: dts: dra7-clock: Add "l3init_960m_gfclk" clock gate ARM: DRA7: hwmod: Add SYSCONFIG for usb_otg_ss ARM: dts: dra7: Add USB related nodes dts: dra7-evm: add USB support Documentation/devicetree/bindings/phy/ti-phy.txt | 7 ++ arch/arm/boot/dts/dra7-evm.dts | 24 ++++ arch/arm/boot/dts/dra7.dtsi | 149 +++++++++++++++++++++++ arch/arm/boot/dts/dra7xx-clocks.dtsi | 12 +- arch/arm/boot/dts/omap4.dtsi | 2 + arch/arm/boot/dts/omap5.dtsi | 2 + arch/arm/mach-omap2/omap_hwmod_7xx_data.c | 22 ++-- drivers/phy/phy-omap-usb2.c | 30 +++-- 8 files changed, 229 insertions(+), 19 deletions(-) -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html