Re: [PATCH 1/4] ARM: dts: ux500: Disable I2C/SPI buses by default

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Nov 25, 2019 at 6:05 PM Stephan Gerhold <stephan@xxxxxxxxxxx> wrote:

> At the moment, all 5 I2C and 6 SPI buses are probed and exposed
> to user-space by default - even if they are not muxed to any pins
> on the board. This means that user-space sees an I2C/SPI bus that
> cannot be actually used properly.
>
> In some cases this was used to put the corresponding pins into
> a low power sleep mode - but even then the pins first need to be
> configured by the board-specific device tree part.
>
> Avoid exposing unconfigured devices to user-space by disabling
> the I2C/SPI buses by default. Enable them in the board device trees
> when needed.
>
> Signed-off-by: Stephan Gerhold <stephan@xxxxxxxxxxx>

All 4 patches applied and pushed to ux500-dts for v5.6!

Yours,
Linus Walleij



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux