Add support for parallax ping and laser ping sensors with just one pin for trigger and echo signal. This driver is based on srf04. In contrast to it it's necessary to change direction of the pin and to request the irq just for the period when the echo is rising and falling. Because this adds a lot of cases there is this individual driver for handling this type of sensors. Add a new configuration variable CONFIG_PING to Kconfig and Makefile. Signed-off-by: Andreas Klinger <ak@xxxxxxxxxxxxx> Reported-by: kbuild test robot <lkp@xxxxxxxxx> Reported-by: Julia Lawall <julia.lawall@xxxxxxx> --- drivers/iio/proximity/Kconfig | 15 ++ drivers/iio/proximity/Makefile | 1 + drivers/iio/proximity/ping.c | 335 +++++++++++++++++++++++++++++++++++++++++ 3 files changed, 351 insertions(+) create mode 100644 drivers/iio/proximity/ping.c diff --git a/drivers/iio/proximity/Kconfig b/drivers/iio/proximity/Kconfig index d53601447da4..37606d400805 100644 --- a/drivers/iio/proximity/Kconfig +++ b/drivers/iio/proximity/Kconfig @@ -58,6 +58,21 @@ config MB1232 To compile this driver as a module, choose M here: the module will be called mb1232. +config PING + tristate "Parallax GPIO bitbanged ranger sensors" + depends on GPIOLIB + help + Say Y here to build a driver for GPIO bitbanged ranger sensors + with just one GPIO for the trigger and echo. This driver can be + used to measure the distance of objects. + + Actually supported are: + - Parallax PING))) (ultrasonic) + - Parallax LaserPING (time-of-flight) + + To compile this driver as a module, choose M here: the + module will be called ping. + config RFD77402 tristate "RFD77402 ToF sensor" depends on I2C diff --git a/drivers/iio/proximity/Makefile b/drivers/iio/proximity/Makefile index 0bb5f9de13d6..c591b019304e 100644 --- a/drivers/iio/proximity/Makefile +++ b/drivers/iio/proximity/Makefile @@ -8,6 +8,7 @@ obj-$(CONFIG_AS3935) += as3935.o obj-$(CONFIG_ISL29501) += isl29501.o obj-$(CONFIG_LIDAR_LITE_V2) += pulsedlight-lidar-lite-v2.o obj-$(CONFIG_MB1232) += mb1232.o +obj-$(CONFIG_PING) += ping.o obj-$(CONFIG_RFD77402) += rfd77402.o obj-$(CONFIG_SRF04) += srf04.o obj-$(CONFIG_SRF08) += srf08.o diff --git a/drivers/iio/proximity/ping.c b/drivers/iio/proximity/ping.c new file mode 100644 index 000000000000..34aff108dff5 --- /dev/null +++ b/drivers/iio/proximity/ping.c @@ -0,0 +1,335 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/* + * PING: ultrasonic sensor for distance measuring by using only one GPIOs + * + * Copyright (c) 2019 Andreas Klinger <ak@xxxxxxxxxxxxx> + * + * For details about the devices see: + * http://parallax.com/sites/default/files/downloads/28041-LaserPING-2m-Rangefinder-Guide.pdf + * http://parallax.com/sites/default/files/downloads/28015-PING-Documentation-v1.6.pdf + * + * the measurement cycle as timing diagram looks like: + * + * GPIO ___ ________________________ + * ping: __/ \____________/ \________________ + * ^ ^ ^ ^ + * |<->| interrupt interrupt + * udelay(5) (ts_rising) (ts_falling) + * |<---------------------->| + * . pulse time measured . + * . --> one round trip of ultra sonic waves + * ultra . . + * sonic _ _ _. . + * burst: _________/ \_/ \_/ \_________________________________________ + * . + * ultra . + * sonic _ _ _. + * echo: __________________________________/ \_/ \_/ \________________ + */ +#include <linux/err.h> +#include <linux/gpio/consumer.h> +#include <linux/kernel.h> +#include <linux/module.h> +#include <linux/of.h> +#include <linux/of_device.h> +#include <linux/platform_device.h> +#include <linux/property.h> +#include <linux/sched.h> +#include <linux/interrupt.h> +#include <linux/delay.h> +#include <linux/iio/iio.h> +#include <linux/iio/sysfs.h> + +struct ping_cfg { + unsigned long trigger_pulse_us; /* length of trigger pulse */ + int laserping_error; /* support error code in */ + /* pulse width of laser */ + /* ping sensors */ + s64 timeout_ns; /* timeout in ns */ +}; + +struct ping_data { + struct device *dev; + struct gpio_desc *gpiod_ping; + struct mutex lock; + int irqnr; + ktime_t ts_rising; + ktime_t ts_falling; + struct completion rising; + struct completion falling; + const struct ping_cfg *cfg; +}; + +static const struct ping_cfg pa_ping_cfg = { + .trigger_pulse_us = 5, + .laserping_error = 0, + .timeout_ns = 18500000, /* 3 meters */ +}; + +static const struct ping_cfg pa_laser_ping_cfg = { + .trigger_pulse_us = 5, + .laserping_error = 1, + .timeout_ns = 15500000, /* 2 meters plus error codes */ +}; + +static irqreturn_t ping_handle_irq(int irq, void *dev_id) +{ + struct iio_dev *indio_dev = dev_id; + struct ping_data *data = iio_priv(indio_dev); + ktime_t now = ktime_get(); + + if (gpiod_get_value(data->gpiod_ping)) { + data->ts_rising = now; + complete(&data->rising); + } else { + data->ts_falling = now; + complete(&data->falling); + } + + return IRQ_HANDLED; +} + +static int ping_read(struct ping_data *data) +{ + int ret; + ktime_t ktime_dt; + s64 dt_ns; + u32 time_ns, distance_mm; + struct platform_device *pdev = to_platform_device(data->dev); + struct iio_dev *indio_dev = iio_priv_to_dev(data); + + /* + * just one read-echo-cycle can take place at a time + * ==> lock against concurrent reading calls + */ + mutex_lock(&data->lock); + + reinit_completion(&data->rising); + reinit_completion(&data->falling); + + gpiod_set_value(data->gpiod_ping, 1); + udelay(data->cfg->trigger_pulse_us); + gpiod_set_value(data->gpiod_ping, 0); + + ret = gpiod_direction_input(data->gpiod_ping); + if (ret < 0) { + mutex_unlock(&data->lock); + return ret; + } + + data->irqnr = gpiod_to_irq(data->gpiod_ping); + if (data->irqnr < 0) { + dev_err(data->dev, "gpiod_to_irq: %d\n", data->irqnr); + mutex_unlock(&data->lock); + return data->irqnr; + } + + ret = request_irq(data->irqnr, ping_handle_irq, + IRQF_TRIGGER_RISING | IRQF_TRIGGER_FALLING, + pdev->name, indio_dev); + if (ret < 0) { + dev_err(data->dev, "request_irq: %d\n", ret); + mutex_unlock(&data->lock); + return ret; + } + + /* it should not take more than 20 ms until echo is rising */ + ret = wait_for_completion_killable_timeout(&data->rising, HZ/50); + if (ret < 0) + goto err_reset_direction; + else if (ret == 0) { + ret = -ETIMEDOUT; + goto err_reset_direction; + } + + /* it cannot take more than 50 ms until echo is falling */ + ret = wait_for_completion_killable_timeout(&data->falling, HZ/20); + if (ret < 0) + goto err_reset_direction; + else if (ret == 0) { + ret = -ETIMEDOUT; + goto err_reset_direction; + } + + ktime_dt = ktime_sub(data->ts_falling, data->ts_rising); + + free_irq(data->irqnr, indio_dev); + + ret = gpiod_direction_output(data->gpiod_ping, GPIOD_OUT_LOW); + if (ret < 0) { + mutex_unlock(&data->lock); + return ret; + } + + mutex_unlock(&data->lock); + + dt_ns = ktime_to_ns(ktime_dt); + if (dt_ns > data->cfg->timeout_ns) { + dev_dbg(data->dev, "distance out of range: dt=%lldns\n", + dt_ns); + return -EIO; + } + + time_ns = dt_ns; + + /* + * read error code of laser ping sensor and give users chance to + * figure out error by using dynamic debuggging + */ + if (data->cfg->laserping_error) { + if ((time_ns > 12500000) && (time_ns <= 13500000)) { + dev_dbg(data->dev, "target too close or to far\n"); + return -EIO; + } + if ((time_ns > 13500000) && (time_ns <= 14500000)) { + dev_dbg(data->dev, "internal sensor error\n"); + return -EIO; + } + if ((time_ns > 14500000) && (time_ns <= 15500000)) { + dev_dbg(data->dev, "internal sensor timeout\n"); + return -EIO; + } + } + + /* + * the speed as function of the temperature is approximately: + * + * speed = 331,5 + 0,6 * Temp + * with Temp in °C + * and speed in m/s + * + * use 343,5 m/s as ultrasonic speed at 20 °C here in absence of the + * temperature + * + * therefore: + * time 343,5 time * 232 + * distance = ------ * ------- = ------------ + * 10^6 2 1350800 + * with time in ns + * and distance in mm (one way) + * + * because we limit to 3 meters the multiplication with 232 just + * fits into 32 bit + */ + distance_mm = time_ns * 232 / 1350800; + + return distance_mm; + +err_reset_direction: + free_irq(data->irqnr, indio_dev); + mutex_unlock(&data->lock); + + if (gpiod_direction_output(data->gpiod_ping, GPIOD_OUT_LOW)) + dev_dbg(data->dev, "error in gpiod_direction_output\n"); + return ret; +} + +static int ping_read_raw(struct iio_dev *indio_dev, + struct iio_chan_spec const *channel, int *val, + int *val2, long info) +{ + struct ping_data *data = iio_priv(indio_dev); + int ret; + + if (channel->type != IIO_DISTANCE) + return -EINVAL; + + switch (info) { + case IIO_CHAN_INFO_RAW: + ret = ping_read(data); + if (ret < 0) + return ret; + *val = ret; + return IIO_VAL_INT; + case IIO_CHAN_INFO_SCALE: + /* + * maximum resolution in datasheet is 1 mm + * 1 LSB is 1 mm + */ + *val = 0; + *val2 = 1000; + return IIO_VAL_INT_PLUS_MICRO; + default: + return -EINVAL; + } +} + +static const struct iio_info ping_iio_info = { + .read_raw = ping_read_raw, +}; + +static const struct iio_chan_spec ping_chan_spec[] = { + { + .type = IIO_DISTANCE, + .info_mask_separate = + BIT(IIO_CHAN_INFO_RAW) | + BIT(IIO_CHAN_INFO_SCALE), + }, +}; + +static const struct of_device_id of_ping_match[] = { + { .compatible = "parallax,ping", .data = &pa_ping_cfg}, + { .compatible = "parallax,laserping", .data = &pa_ping_cfg}, + {}, +}; + +MODULE_DEVICE_TABLE(of, of_ping_match); + +static int ping_probe(struct platform_device *pdev) +{ + struct device *dev = &pdev->dev; + struct ping_data *data; + struct iio_dev *indio_dev; + + indio_dev = devm_iio_device_alloc(dev, sizeof(struct ping_data)); + if (!indio_dev) { + dev_err(dev, "failed to allocate IIO device\n"); + return -ENOMEM; + } + + data = iio_priv(indio_dev); + data->dev = dev; + data->cfg = of_device_get_match_data(dev); + + mutex_init(&data->lock); + init_completion(&data->rising); + init_completion(&data->falling); + + data->gpiod_ping = devm_gpiod_get(dev, "ping", GPIOD_OUT_LOW); + if (IS_ERR(data->gpiod_ping)) { + dev_err(dev, "failed to get ping-gpios: err=%ld\n", + PTR_ERR(data->gpiod_ping)); + return PTR_ERR(data->gpiod_ping); + } + + if (gpiod_cansleep(data->gpiod_ping)) { + dev_err(data->dev, "cansleep-GPIOs not supported\n"); + return -ENODEV; + } + + platform_set_drvdata(pdev, indio_dev); + + indio_dev->name = "ping"; + indio_dev->dev.parent = &pdev->dev; + indio_dev->info = &ping_iio_info; + indio_dev->modes = INDIO_DIRECT_MODE; + indio_dev->channels = ping_chan_spec; + indio_dev->num_channels = ARRAY_SIZE(ping_chan_spec); + + return devm_iio_device_register(dev, indio_dev); +} + +static struct platform_driver ping_driver = { + .probe = ping_probe, + .driver = { + .name = "ping-gpio", + .of_match_table = of_ping_match, + }, +}; + +module_platform_driver(ping_driver); + +MODULE_AUTHOR("Andreas Klinger <ak@xxxxxxxxxxxxx>"); +MODULE_DESCRIPTION("PING sensors for distance measuring using one GPIOs"); +MODULE_LICENSE("GPL"); +MODULE_ALIAS("platform:ping"); -- 2.11.0
