Use the now-preferred generic phy reset properties instead of the dwmac-specific ones. Signed-off-by: Robin Murphy <robin.murphy@xxxxxxx> --- arch/arm64/boot/dts/rockchip/rk3399-nanopi4.dtsi | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/arch/arm64/boot/dts/rockchip/rk3399-nanopi4.dtsi b/arch/arm64/boot/dts/rockchip/rk3399-nanopi4.dtsi index dd16c80d923e..170f7ed6d773 100644 --- a/arch/arm64/boot/dts/rockchip/rk3399-nanopi4.dtsi +++ b/arch/arm64/boot/dts/rockchip/rk3399-nanopi4.dtsi @@ -152,9 +152,6 @@ phy-handle = <&rtl8211e>; phy-mode = "rgmii"; phy-supply = <&vcc3v3_s3>; - snps,reset-active-low; - snps,reset-delays-us = <0 10000 30000>; - snps,reset-gpio = <&gpio3 RK_PB7 GPIO_ACTIVE_LOW>; tx_delay = <0x28>; rx_delay = <0x11>; status = "okay"; @@ -168,6 +165,9 @@ reg = <1>; interrupt-parent = <&gpio3>; interrupts = <RK_PB2 IRQ_TYPE_LEVEL_LOW>; + reset-assert-us = <10000>; + reset-deassert-us = <30000>; + reset-gpios = <&gpio3 RK_PB7 GPIO_ACTIVE_LOW>; }; }; }; -- 2.21.0.dirty
