On Tue, Sep 17, 2019 at 06:19:13PM +0100, Russell King - ARM Linux admin wrote: > whether you can get the link to come up at all. You might need to see > whether wiggling the RJ45 helps (I've had that sort of thing with some > cables.) > > You might also need "ethtool -s eth0 advertise ffcf" after trying that > if it doesn't work to take the gigabit speeds out of the advertisement. > > Thanks. > > drivers/net/phy/at803x.c | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c > index b3893347804d..85cf4a4a5e81 100644 > --- a/drivers/net/phy/at803x.c > +++ b/drivers/net/phy/at803x.c > @@ -296,6 +296,11 @@ static int at803x_config_init(struct phy_device *phydev) > if (ret < 0) > return ret; > > + /* Disable smartspeed */ > + ret = phy_modify(phydev, 0x14, BIT(5), 0); > + if (ret < 0) > + return ret; > + > /* The RX and TX delay default is: > * after HW reset: RX delay enabled and TX delay disabled > * after SW reset: RX delay enabled, while TX delay retains the Hi, Could you try this patch instead - it seems that the PHY needs to be soft-reset for the write to take effect, and _even_ for the clearance of the bit to become visible in the register. I'm not expecting this on its own to solve anything, but it should at least mean that the at803x doesn't modify the advertisement registers itself. It may mean that the link doesn't even come up without forcing the advertisement via the ethtool command I mentioned before. Thanks. drivers/net/phy/at803x.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c index b3893347804d..69a58c0e6b42 100644 --- a/drivers/net/phy/at803x.c +++ b/drivers/net/phy/at803x.c @@ -296,6 +296,16 @@ static int at803x_config_init(struct phy_device *phydev) if (ret < 0) return ret; + /* Disable smartspeed */ + ret = phy_modify(phydev, 0x14, BIT(5), 0); + if (ret < 0) + return ret; + + /* Must soft-reset the PHY for smartspeed disable to take effect */ + ret = genphy_soft_reset(phydev); + if (ret < 0) + return ret; + /* The RX and TX delay default is: * after HW reset: RX delay enabled and TX delay disabled * after SW reset: RX delay enabled, while TX delay retains the -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTC broadband for 0.8mile line in suburbia: sync at 12.1Mbps down 622kbps up According to speedtest.net: 11.9Mbps down 500kbps up
