Quoting Vinod Koul (2019-08-14 05:49:56)
> Add base DTS file for pm8150 along with GPIOs
>
> Signed-off-by: Vinod Koul <vkoul@xxxxxxxxxx>
> ---
> arch/arm64/boot/dts/qcom/pm8150.dtsi | 41 ++++++++++++++++++++++++++++
> 1 file changed, 41 insertions(+)
> create mode 100644 arch/arm64/boot/dts/qcom/pm8150.dtsi
>
> diff --git a/arch/arm64/boot/dts/qcom/pm8150.dtsi b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> new file mode 100644
> index 000000000000..b533e254a203
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm8150.dtsi
> @@ -0,0 +1,41 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +// Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
> +// Copyright (c) 2019, Linaro Limited
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +&spmi_bus {
> + pm8150_0: pm8150@0 {
I think node name should be 'pmic'
> + compatible = "qcom,spmi-pmic";
This should also have the model number? "qcom,pm8150"?
> + reg = <0x0 SPMI_USID>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + pm8150_gpios: gpio@c000 {
> + compatible = "qcom,pm8150-gpio";
> + reg = <0xc000>;
> + gpio-controller;
> + #gpio-cells = <2>;
> + interrupts = <0 0xc0 0 IRQ_TYPE_NONE>,
> + <0 0xc1 0 IRQ_TYPE_NONE>,
> + <0 0xc2 0 IRQ_TYPE_NONE>,
> + <0 0xc3 0 IRQ_TYPE_NONE>,
> + <0 0xc4 0 IRQ_TYPE_NONE>,
> + <0 0xc5 0 IRQ_TYPE_NONE>,
> + <0 0xc6 0 IRQ_TYPE_NONE>,
> + <0 0xc7 0 IRQ_TYPE_NONE>,
> + <0 0xc8 0 IRQ_TYPE_NONE>,
> + <0 0xc9 0 IRQ_TYPE_NONE>,
> + <0 0xca 0 IRQ_TYPE_NONE>,
> + <0 0xcb 0 IRQ_TYPE_NONE>;
> + };
> + };
> +
> + qcom,pm8150@1 {
Same comment, pmic@1.
> + compatible ="qcom,spmi-pmic";
> + reg = <0x1 SPMI_USID>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> + };
> +};
