This patchset holds some common changes that were never upstreamed. With latest downstream kernel upgrade, I took the aproach to select mainline devicetrees and atomically add missing stuff for downstream. These patches I send here are separated out with changes that also have a benfit for mainline. Philippe Changes in v4: - Added Marcel Ziswiler's Ack - Added Marcel Ziswiler's Ack - Make scl-gpios and sda-gpios (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN) - Change commit title to Michal's suggestion - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Add Marcel Ziswiler's Ack - Move can nodes to module deviceteree include imx6ull-colibri.dtsi - Add Marcel Ziswiler's Ack - New patch as of the recommendation from Marcel on ML Changes in v3: - Add new commit message from Stefan's proposal on ML - Fix commit message - Fix commit title to "...imx6-apalis:..." - New patch to make use of ARM: dts: imx7-colibri: fix 1.8V/UHS support Changes in v2: - Deleted touchrevolution downstream stuff - Use generic node name - Better comment - Changed commit title to '...imx6qdl-apalis:...' - Deleted touchrevolution downstream stuff - Use generic node name - Put a better comment in there - Commit title - Removed f0710a, that is downstream only - Changed to generic node name - Better comment Igor Opaniuk (1): ARM: dts: imx6qdl-colibri.dtsi: UHS-I support for v1.1a hw Marcel Ziswiler (1): ARM: dts: imx7-colibri: make sure module supplies are always on Max Krummenacher (2): ARM: dts: imx6ull-colibri: reduce v_batt current in power off ARM: dts: imx6ull: improve can templates Oleksandr Suvorov (1): ARM: dts: imx7-colibri: add recovery for I2C for iMX7 Philippe Schenker (13): ARM: dts: imx7-colibri: prepare module device tree for FlexCAN ARM: dts: imx7-colibri: Add sleep mode to ethernet ARM: dts: imx7-colibri: Add touch controllers ARM: dts: imx6qdl-colibri: add phy to fec ARM: dts: imx6qdl-colibri: Add missing pin declaration in iomuxc ARM: dts: imx6qdl-apalis: Add sleep state to can interfaces ARM: dts: imx6-apalis: Add touchscreens used on Toradex eval boards ARM: dts: imx6-colibri: Add missing pinmuxing to Toradex eval board ARM: dts: imx6ull-colibri: Add sleep mode to fec ARM: dts: imx6ull-colibri: Add watchdog ARM: dts: imx6ull-colibri: Add general wakeup key used on Colibri ARM: dts: imx6ull-colibri: Add touchscreen used with Eval Board ARM: dts: imx7-colibri: Add UHS support to eval board Stefan Agner (3): ARM: dts: imx7-colibri: disable HS400 ARM: dts: imx7-colibri: add GPIO wakeup key ARM: dts: imx7-colibri: fix 1.8V/UHS support arch/arm/boot/dts/imx6dl-colibri-eval-v3.dts | 39 ++++++ arch/arm/boot/dts/imx6q-apalis-eval.dts | 13 ++ arch/arm/boot/dts/imx6q-apalis-ixora-v1.1.dts | 13 ++ arch/arm/boot/dts/imx6q-apalis-ixora.dts | 13 ++ arch/arm/boot/dts/imx6qdl-apalis.dtsi | 27 ++++- arch/arm/boot/dts/imx6qdl-colibri.dtsi | 68 ++++++++++- .../arm/boot/dts/imx6ull-colibri-eval-v3.dtsi | 38 ++++++ .../arm/boot/dts/imx6ull-colibri-nonwifi.dtsi | 2 +- arch/arm/boot/dts/imx6ull-colibri-wifi.dtsi | 2 +- arch/arm/boot/dts/imx6ull-colibri.dtsi | 64 +++++++++- arch/arm/boot/dts/imx7-colibri-eval-v3.dtsi | 49 +++++++- arch/arm/boot/dts/imx7-colibri.dtsi | 112 ++++++++++++++++-- 12 files changed, 410 insertions(+), 30 deletions(-) -- 2.22.0
