To enable burst clock mode, add the fsl,burst-clk-enable property to the weim bus's devicetree node. Example: weim: weim@21b8000 { compatible = "fsl,imx6q-weim"; reg = <0x021b8000 0x4000>; clocks = <&clks 196>; #address-cells = <2>; #size-cells = <1>; ranges = <0 0 0x08000000 0x08000000>; fsl,weim-cs-gpr = <&gpr>; fsl,burst-clk-enable; client-device@0,0 { compatible = "something"; reg = <0 0 0x02000000>; #address-cells = <1>; #size-cells = <1>; bank-width = <2>; fsl,weim-cs-timing = <0x00620081 0x00000001 0x1c022000 0x0000c000 0x1404a38e 0x00000000>; }; }; Signed-off-by: Sven Van Asbroeck <TheSven73@xxxxxxxxx> --- drivers/bus/imx-weim.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+) diff --git a/drivers/bus/imx-weim.c b/drivers/bus/imx-weim.c index db74334ca5ef..cb7d5504a22a 100644 --- a/drivers/bus/imx-weim.c +++ b/drivers/bus/imx-weim.c @@ -19,6 +19,8 @@ struct imx_weim_devtype { unsigned int cs_count; unsigned int cs_regs_count; unsigned int cs_stride; + unsigned int wcr_offset; + unsigned int wcr_bcm; }; static const struct imx_weim_devtype imx1_weim_devtype = { @@ -37,6 +39,8 @@ static const struct imx_weim_devtype imx50_weim_devtype = { .cs_count = 4, .cs_regs_count = 6, .cs_stride = 0x18, + .wcr_offset = 0x90, + .wcr_bcm = BIT(0), }; static const struct imx_weim_devtype imx51_weim_devtype = { @@ -192,6 +196,7 @@ static int __init weim_parse_dt(struct platform_device *pdev, struct device_node *child; int ret, have_child = 0; struct cs_timing_state ts = {}; + u32 reg; if (devtype == &imx50_weim_devtype) { ret = imx_weim_gpr_setup(pdev); @@ -199,6 +204,17 @@ static int __init weim_parse_dt(struct platform_device *pdev, return ret; } + if (of_property_read_bool(pdev->dev.of_node, "fsl,burst-clk-enable")) { + if (devtype->wcr_bcm) { + reg = readl(base + devtype->wcr_offset); + writel(reg | devtype->wcr_bcm, + base + devtype->wcr_offset); + } else { + dev_err(&pdev->dev, "burst clk mode not supported.\n"); + return -EINVAL; + } + } + for_each_available_child_of_node(pdev->dev.of_node, child) { ret = weim_timing_setup(&pdev->dev, child, base, devtype, &ts); if (ret) -- 2.17.1