Add the initial configuration for clocks that need default parent and rate
setting. This is based on the vendor tree clock provider parents and rates
configuration except this is doing the setup in dts rather then using clock
consumer API in a clock provider driver.
Signed-off-by: Abel Vesa <abel.vesa@xxxxxxx>
---
Changes since v1:
- removed the PCIE and CSI clocks parent setting since
that should be done from their driver, as suggested
by Leonard.
arch/arm64/boot/dts/freescale/imx8mq.dtsi | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/arch/arm64/boot/dts/freescale/imx8mq.dtsi b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
index d09b808..c286f20 100644
--- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
@@ -489,6 +489,20 @@
clock-names = "ckil", "osc_25m", "osc_27m",
"clk_ext1", "clk_ext2",
"clk_ext3", "clk_ext4";
+ assigned-clocks = <&clk IMX8MQ_VIDEO_PLL1>,
+ <&clk IMX8MQ_CLK_AHB>,
+ <&clk IMX8MQ_CLK_NAND_USDHC_BUS>,
+ <&clk IMX8MQ_CLK_AUDIO_AHB>,
+ <&clk IMX8MQ_VIDEO_PLL1_REF_SEL>,
+ <&clk IMX8MQ_CLK_NOC>;
+ assigned-clock-parents = <0>,
+ <&clk IMX8MQ_SYS1_PLL_133M>,
+ <&clk IMX8MQ_SYS1_PLL_266M>,
+ <&clk IMX8MQ_SYS2_PLL_500M>,
+ <&clk IMX8MQ_CLK_27M>,
+ <&clk IMX8MQ_SYS1_PLL_800M>;
+ assigned-clock-rates = <593999999>;
+
};
src: reset-controller@30390000 {
--
2.7.4
